Radio Shack TAD-1010 owner manual Telephone Operation, ANSWERING/MAKING a Call

Page 17

43-771.fm Page 17 Friday, August 13, 1999 2:59 PM

TELEPHONE OPERATION

Important: If you move the handset out- side the base’s range, the handset will not operate properly and a call in progress might be disconnected (see “Troubleshooting” on Page 32).

ANSWERING/MAKING A CALL

To answer a call, if the handset is on the base, simply lift the handset and be- gin your conversation.

To answer a call if the handset is not on the base, press any key on the handset (except OFF) before speaking.

Notes:

Both the IN USE indicator on the base and the TALK indicator on the handset flash when you receive a call and light steadily while the handset is in use.

If the handset’s ringer is turned on and you press OFF while the hand- set is ringing, the handset’s ringer turns off for that call only, then it automatically turns on when the next call comes in.

To make a call, pick up the handset and press TALK. When the IN USE indicator lights steadily and you hear a dial tone, dial the desired phone number or mem- ory number (see “Memory Operation” on Page 20).

Notes:

Before you get a dial tone, there might be a slight delay while the TAD-1010 searches through its 10 channels to find a clear channel. While the phone searches, the TALK indicator on the handset blinks.

If you hear a short buzz when you press TALK, or the PRIVACY/LOW BATT indicator flashes, the handset batteries need recharging.

To end a call, place the handset on the base, press TALK again, or press OFF on the handset.

ADJUSTING THE HANDSET’S VOLUME

To adjust the handset’s volume up or

down during a call, press or on the side of the handset.

17

Image 17
Contents TAD-1010 FCC Statement Read this Before InstallationCordless Telephone Features FeaturesTAD Features Fm Page 5 Friday, August 13, 1999 259 PM Contents FCC Wants You to Know Installing Backup Battery InstallationMounting the Base on a Wall Selecting a LocationPlacing the Base on a Desktop Mounting on a Wall Plate Mounting Directly on the Wall Fm Page 12 Friday, August 13, 1999 259 PM Telephone Preparation Installing the Handset Battery PackCharging the Handset Battery Pack Setting the PULSE/ Tone Switch Setting the Telephone RingerTurning Off the Ringer Checking the RingerANSWERING/MAKING a Call Telephone OperationUsing Privacy Using RedialUsing Hold Using FlashChanging Channels UsingStoring a Number in Memory Memory OperationDialing a Stored Number Chain Dialing Service NumbersStoring a Pause in Memory Setting the Remote Operation Security Code TAD Setup and Basic OperationSetting the Number of Rings Setting the Number of Mailboxes Setting the DAY and TimeRecording an Announcement Selecting AN AnnouncementChecking the Outgoing Announcement Recording a Memo Setting the TAD to Answer CallsPlaying Messages Erasing Messages Adjusting the TAD’S VolumeAccessing the TAD by Remote Using the TOLL-SAVERRemote Operation From Another Phone LineUsing Remote Commands Remote Operation Commands Problem Suggestion TroubleshootingFm Page 33 Friday, August 13, 1999 259 PM Out of Range with a Call in Progress OUT of Range IndicationsOut of Range with No Call Care and Maintenance Lightning FCC Wants YOU to KnowFm Page 37 Friday, August 13, 1999 259 PM Fm Page 38 Friday, August 13, 1999 259 PM Fm Page 39 Friday, August 13, 1999 259 PM Radio Shack