Siemens V1.2.33 manual Specifying the Number of Scans, Hiding List Columns

Listing Connected IP Phones

Specifying the Number of Scans

You can specify the number of scans for a LAN-based scan or mark the scan as continuous. Select the required option under Scan parameters.

You can select the maximum number of scans in the drop-down list or se- lect "Continuous" for non-stop scanning.

There are two reasons for entering multiple scans:

1.An optiPoint is not fully installed or is in "Local mode" and is therefore unable to answer while the scan is in progress.

2.The scan process uses the UDP protocol that does not guarantee to forward the solicitation message or deliver a reply. Under these cir- cumstances, multiple scans are more effective in certain network en- vironments.

Hiding List Columns

You can hide and display columns before or after the scan. Click the View drop-down menu on the menu bar and select or deselect the required op- tion.

The MAC address option is not selected in this example so the column is hidden.

11