Siemens HWCD8518(3)P/TSDL user manual Descriptions of displays of the handset Base

Page 5

Gigaset 4010 Comfort, CHIN eng, A31008-G4010-C102-1-7619 umschl_v.fm 16.10.03

Note: The dial mode of this phone has been set to tone dialing. If you want to change it to pulse dialing, please refer to the descriptions in the “Tone/Pulse Switch” section. If you are not sure which mode to apply, please consult your phone service company.

10.Place your base away from the “interference sources” (e.g.: TV, PC, microwave oven, refrigerator, etc.) and in a central position of its range, and if you can place it at a higher position, it will work better. To obtain the best performance, pull the antenna to its maximum length.

11.Adjust the flash time to a required period of time.

Note: Use the power adapter in the package. Using other power adapters might cause damages to your phone.

Note: The dial mode of this phone has been set to be tone dialing.

Descriptions of displays of the handset and

base

Line

Number of callers

Channel switch (handset)

VIP records

Batt. fully charged (handset)

Batteries flat (handset)

New incoming call records

Outgoing call records

Directory

Repeat call records

The ringer is programmed off (Hour: minute (Date-month) (handset)

Date (base)

Pin lock (base)

Base in use, handset is in standby (handset)

5

Image 5

Contents Expandable cordless phone system Be inspiredTable of contents Appendix Interface Illustration Pack contains Installing the phonePreparing to use the phone Descriptions of displays of the handset Base Description of the function keys on the handset Descriptions of the function keys IndicatorsPage Tone/pulse switch SettingsFlash timing switch Setting the date and the timeAdding IDD code to the incoming calls Handset and base Adjust the LCD light handset and baseAdding external mark to the incoming calls Handset and base Selecting Ringer Tones handset and baseSelect Caller Ringer Tones handset Base Selecting VIP Ringer Tones handset BaseRegistering the Handset INT Activating/deactivating RingerBase Adjusting the ringer volume Adjust VolumeHandset and base HandsetMaking a Call Answering/Ending a callOutgoing call Last number redialing Basic operationDeleting a single outgoing number External call and power indicatorsDeleting all outgoing numbers Call ending functionBase holding Intercom modeTransferring a call Searching for handset / base and intercomTransferring a call from the handset to the base Displaying incoming numbersTransferring a call from one handset to another Incoming call recordsBrowsing incoming call records Deleting a single incoming call number DirectoryDeleting all incoming numbers Browsing and dial the incoming numbersStoring phone numbers Setting VIP callsBrowsing lists in the Directory Adding dialing pauseDeleting all numbers in the Directory Dialing from stored caller-IDDeleting a single number in the Directory Parts of a long-distance number Location in the Directory Speed dialStoring IP numbers IP dialing and dial back Setting PIN and Lock CodePIN lock Unlocking Battery indicationMechanical lock Ringing backSafe use of the batteries Replacing batteriesIndicating information CareCalls Hotline Handset Base Top and side Base Bottom and Rear