Siemens HWCD8518(3)P/TSDL user manual Calls

Page 24

Gigaset 4010 Comfort, CHIN eng, A31008-G4010-C102-1-7619 umschl_v.fm 16.10.03

Q&A

Caller numbers

Question					Answer
No display					Replace the batteries and be sure they are
					inserted correctly.
					Have you applied for the Incoming Call
					Display service from your phone service
					company?
Show error about the caller’s information					If the base receives any information that is
					different from the valid incoming call
					information, it will show error.
Calls
	Question		Answer
	No pulse or tone		Check the installation:
	dialing tone		Did you plug the phone cord into the location marked with
			“Phone Line” at the back of the base, then plug the other
			end of the cord into the socket of the phone cord on the
			wall?
			Plug the phone cord out of the base, then plug it into
			another phone set to see if the other phone meets the same
			problem. If so, the problem is caused by phone line or
			phone service.
			Be sure the batteries are full.
			Be sure the insertion of the batteries is correct.
	Can’t	make	Be sure that the settings of the tone and pulse dialing are
	calls but	the	correct.
	keyboard
	sounds normal
	No ring		Be sure the ring is set On
			Maybe you have equipped with too many extensions,
			unplug some to see if the problem still exists.

Dialed out call records (Dialing from CID)

-Did you enter the correct location code of the call record?

-Did you dial out the call record correctly?

-Be sure the settings of the tone and pulse dialing are correct.

-Did you re-save the records after replacing batteries?

24

Image 24

Contents Be inspired Expandable cordless phone systemTable of contents Appendix Interface Illustration Installing the phone Preparing to use the phonePack contains Descriptions of displays of the handset Base Descriptions of the function keys Indicators Description of the function keys on the handsetPage Settings Tone/pulse switchFlash timing switch Setting the date and the timeAdjust the LCD light handset and base Adding IDD code to the incoming calls Handset and baseAdding external mark to the incoming calls Handset and base Selecting Ringer Tones handset and baseSelecting VIP Ringer Tones handset Base Select Caller Ringer Tones handset BaseRegistering the Handset INT Activating/deactivating RingerAdjust Volume Base Adjusting the ringer volumeHandset and base HandsetAnswering/Ending a call Making a CallOutgoing call Last number redialing Basic operationExternal call and power indicators Deleting a single outgoing numberDeleting all outgoing numbers Call ending functionIntercom mode Base holdingTransferring a call Searching for handset / base and intercomDisplaying incoming numbers Transferring a call from the handset to the baseTransferring a call from one handset to another Incoming call recordsBrowsing incoming call records Directory Deleting a single incoming call numberDeleting all incoming numbers Browsing and dial the incoming numbersSetting VIP calls Storing phone numbersBrowsing lists in the Directory Adding dialing pauseDialing from stored caller-ID Deleting a single number in the DirectoryDeleting all numbers in the Directory Speed dial Storing IP numbersParts of a long-distance number Location in the Directory Setting PIN and Lock Code PIN lock IP dialing and dial back Battery indication UnlockingMechanical lock Ringing backReplacing batteries Safe use of the batteriesIndicating information CareCalls Hotline Handset Base Top and side Base Bottom and Rear