BT 2110 manual Install the rechargeable Battery in the handset

Page 11

Synergy 2110 - Edition 5 – 23rd October ’00 (3375)

Install the rechargeable

2battery in the handset

The Synergy 2110 uses a Nickel Cadmium (Ni-Cd) battery pack supplied. Take care to connect the battery as shown and replace the battery cover.

Charge the handset battery

3for at least 16 hours

Before you use your Synergy 2110 for the first time, it is important to have the handset battery fully charged. We recommend that you leave the Synergy 2110 on charge for at least 16 hours.

Under no circumstances should non-rechargeable batteries be used. Only use the approved batteries. Using unapproved batteries will invalidate your guarantee and may damage the telephone.

Place the handset on the base. The red charging light comes on. The handset should come pre-registered to the base station as 1 and this is shown in the top right corner of the display.

The battery symbol is also shown. It flashes during charging. Once the handset is fully charged, the display shows a full battery symbol.

Battery levels

0-50% 50-100% 100%

flashing

Battery low warning.

If the handset battery symbol is empty and flashing, and you hear a warning beep every 10 seconds, you will need to recharge your handset before you can use it.

Battery performance

To keep your battery in the best condition, leave the handset off the base station for a few hours at a time (after the initial 16 hour charge).

After charging your Synergy handset for the first time, subsequent charging time for the battery is approximately 4-5 hours. Battery and case may become warm during charging. This is normal and not dangerous.

Under ideal conditions, the handset battery should give about 6 hours talktime or 100 hours standby on a single charge.

Please note, however, that a new Nickel Cadmium (Ni-Cd) battery does not reach its full capacity until it has been in normal use for several days.

Fully discharging the batteries at least once a week will help them to last as long as possible. However, the charge capacity of rechargeable batteries will reduce with time as they wear out, so reducing the talk/standby time of the handset. Eventually they will need to be replaced.

SETTING UP

9

Page 10 Page 12
Image 11
Page 10 Page 12
Contents User Guide Synergy 2110 Edition 5 23rd October ’00 Int/Secrecy At a glanceExplanation of the display icons Index This guideKey features Building up a phone system IntroductionFor your records Unpacking your Synergy2110Safety instructions Plan the location of your Synergy Setting upConnect the power cable Charge the handset battery For at least 16 hours Install the rechargeable Battery in the handsetConnect the telephone line cord Fitting the belt-clipMaking and receiving calls Using your Synergy 2110 telephoneTo store a number in the memory Using the 10 number memoryTo adjust the earpiece volume SecrecyTo store a direct call number Direct callTo enter a pause in a stored number To delete an entry To dial a number stored in the memoryTo dial a direct call number To cancel the direct call numberTo adjust the ringer melody Handset settingsTo adjust the handset ringer volume To switch the keytones off and onBase station settings To switch auto answer on or off To view the Calls List BT Select ServicesCaller Display Service To use Call Waiting Call WaitingTo delete a number from the Calls List Other services To register a handset Using additional handsetsTo call another handset To hold a three-way conversationTo register your handset with another base station Operating with additional base stationsEmergency calls HelpCheck that General information GuaranteeTo automatically insert a pause Switchboard External Line access codeSwitchboard compatibility Technical informationGo to Tone Dialling modeTo adjust Recall settings Dect IndexPIN Offices worldwide
Top Page Image Contents