BT 1250 Classic manual Wall mounting, 122 mm

Page 29

On-Air 1250 Classic user guide ~ 1st Edition ~ 7th August ’01 ~ 4073

Wall mounting

1

1Push the base-mount forward onto the rear of the base.

2

122 mm

2Once slotted into the rear of the base, slide upwards to lock into position.

WALL PLUG SCREW

WALL

122mm

If wall mounting your BT On-Air 1250 Classic, use this guide for position.

•Make sure that you are not drilling into any hidden wiring and check that the power cable will reach from the mains socket to the charger. Switch the power adaptor off at the mains and remove the adaptor plug from its socket.

•Drill two holes 25mm deep using a 3mm drill, 122mm apart to take the wall plugs.

•Put wall plugs into the drill holes and then insert both screws. Leave 2-3mm between the head of the screw and the wall. You are now able to mount the base to the wall.

•Fit the base onto the two screws. If necessary, tighten or loosen the screws for the best fit.

•Put the handset back in the base and switch the power back on at the wall socket.

29

Image 29

Contents BT On-Air 1250 Classic Base At a glanceHandset This guide At a glance Using additional handsets Introduction BasesIntroduction Safety informationUnpacking your BT On-Air 1250 Classic For your recordsConnect the power supply and switch on Setting upPlan the location PlinthFrom any BT Shop or from the Helpline on 0845 601 Charge the handset battery for at least 16 hoursChanging your handset fascias Connect the telephone line cord after charging your handsetCall timer Using the telephoneCall Monitor Making and ending callsSecrecy To switch secrecy on/offRedial To delete all numbers shown in the redial listPaging handsets Number memoryCaller Display Internal callsTransferring calls To make an internal call to another handsetKeypad beeps and volume Handset settingsCalls list To view the Calls listTo set the date Ringer melody Silent ringTo change base station priority Base settingsTo change your System Code System CodeTo set the time and date Please see To record your own outgoing message OGMTo listen to your outgoing message To delete your outgoing messagesFor Answer and record Press the 3 button For Answer onlyTo switch the answering machine on from the base To adjust the time allowed for recording incoming messagesTo switch the answering machine on from the handset Playing your messages Deleting all messages Answering machine operation during message playbackTo record a memo message To play messages from the handsetTo set up call screening VIP featureTo set up and change the VIP access code Press the Intercom button To access your answering machine from a remote phone Remote accessTo change the remote access code Answering machine control functions Using additional handsets and bases Using additional handsets and basesRegistering additional handsets At the basePress and hold down Technical information GuaranteeGeneral information Switchboard external line access code Switchboard compatibilityRecall To activate RecallPress OK to store 122 mm Wall mountingIndex VIP Page To the answering machine functions Quick GuideFunction Switch answering machine on Play messages