Setting up follow these steps to get your Synergy 900 ready for use.
1.To plan the location of the base station
Your Synergy 900 works by sending and receiving radio signals between the base station and the handset.
The strength of the signal depends on where you site the base station. The higher the base station is located, the better. An upstairs room is ideal. The following points should be considered:
•It should be within 2 metres of a power socket and phone socket otherwise extension cables will be required
•Try to avoid locations near metallic obstructions or electrical appliances, such as TV sets, fridges, computers, fluorescent lights, radiators, metal pipes and metal window frames.
2. Connect the power cable
Plug the power cable into the power socket on the underside of your Synergy 900. When the power is switched on, the base station POWER light comes on.
3.Install the rechargeable battery in the handset
Hold the handset with the keypad facing down, remove the clear plastic directory label cover and press and slide open the battery compartment.
Push
BATTERY
Slide
Insert the battery pack inside the battery compartment and slide the battery compartment cover shut. Replace the directory label cover.
WARNING
It is recommended that the line cord is not connected until the handset is fully charged. This will prevent the risk of the phone being answered prior to the battery being fully charged and therefore not working to its optimum capacity.
6