Cisco Systems SPA302D manual Configuring Network Settings

Using Your Cisco SPA302D	2
Configuring Phone Settings

•Date and Time

•Handset Settings

•Update Software

•Factory Reset

•Phone Info

Configuring Network Settings

You can enter or modify the network settings on your handset. These settings indicate the method that your handset and base station use to connect to the Internet.

NOTE You should only change this setting if advised to do so by your phone system administrator.

STEP 1 From the Settings menu, choose Network Settings.

STEP 2 Enter the PIN code (available from your phone system administrator). By default, there is no PIN code. Press Confirm.

STEP 3 Press the Right and Left arrow buttons on the navigation keypad to scroll through the available network settings and press Confirm to change the selected setting. You can choose from the following settings:

•DHCP (most common)—The Cisco SPA302D and the Cisco SPA232D receive an IP address from the DHCP server on your network (typically, the router or switch to which your hardware is connected).

•Static IP—Choose this setting if you need the Cisco SPA302D to have an assigned IP address that does not change. Enter the IP address, subnet mask, gateway address and DNS server addresses.

•PPPoE—Choose this setting if you have a Point-to-Point Protocol over Ethernet connection to the Internet. Enter your username, password, and service information for your Internet connection.

STEP 4 Press Confirm to save your changes.

Cisco SPA302D Mobility Enhanced Cordless Handset User Guide 27