Polk Audio 400 manual Mounting the Surroundbar 500 CHT SDA Control Module, Overall Dimensions

MOUNTING THE SURROUNDBAR 500 CHT SDA CONTROL MODULE

The SurroundBar 500 CHT SDA Control Module can be mounted on a wall, either vertically or horizontally, into a rack using the supplied rack mount ears, or it may be placed on a flat surface. The location of your other electronic components will determine which location will work best for you.

Wall mounted vertically or horizontally.

Rack mounted using supplied rack mount ears.

Placed on a flat surface.

WALL MOUNTING THE SDA CONTROL MODULE

Overall Dimensions

1.8" H (20.32cm)

2.17" W (43.18cm)

Keyhole Slots

3.14 3/4" W (37.47cm)

2

1

3

1.Determine if you want to mount the SDA Control Module vertically or horizontally. Then hold it in your intended location to be sure there are no obstructions to the SurroundBar and to your receiver, and to determine

the length of the speaker wires you will run for each channel from your receiver to the SDA Control Module.

2.Using the SDA Control Module Wall Mount Template, mark and drill the holes for the mounting screws

or wall anchors as appropriate. Use a molly bolt or wall anchor if a second stud is not available.

3.The SurroundBar cable plugs into the SDA Control Module and the SurroundBar. Run speaker wire (not included) from your receiver to the SDA Control Module. Make the appro- priate connections based on whether you are using the 500 CHT in 7CH, 5CH or LCR mode (see pages 8 - 10).

4.With the SDA Control Module wired and the SurroundBar cable plugged in, set the 7CH, 5CH or LCR switch to the appropriate setting and hang the module on the wall.

5.Tug gently on the module while holding it from below to ensure it has seated properly on its keyhole slots.