Multi-Link ML-001, ML-100 manual Panic, System Failure, Phone Line Failure

ADVANCED PROGRAMMING

To enable alert zone feature, follow the instructions below.

Step	Keys	Function	Description	Note
1	[PROG]	Enter Program-	Enter master	3 beeps for valid
	[MPIN]	ming mode	password to	password. 1 long beep
			programming mode	for invalid password.
2	[8]	Select Alert		After [8] is entered,
		Zone.		some zone LEDs will
				flash or stay on. This
				indicates whether alert
				zone is selected.
3	Disable	Select which	Refer to the	If alert zone is selected,
	Alert Zone:	zone you	diagram below to	that zone LED will be on.
	[1] to [5]	would like to	select the	If it is not selected, the
	Enable	select as Alert	appropriate	LED will flash. You are
		Zone.	setting.	allow to make multiple
	Alert Zone:
				changes before terminat-
	[6] to [0].
				ing programming mode.
4	[PROG]	Terminate		PROG LED will be
	when	programming		off.
	finished.	mode.

	DISABLE	ENABLE	®
	ALERT ZONE ALERT ZONE		This row	:
Zone 1	Button [1]	Button [6]	Buttons to
			Disable Alert Zone
Zone 2	Button [2]	Button [7]	Zone LED : Flash
Zone 3	Button [3]	Button [8]
Zone 4	Button [4]	Button [9]
Zone 5	Button [5]	Button [0]	This row	:
			Buttons to
			Enable Alert Zone
			Zone LED : ON

–34–

OPERATION

Panic

Pressing the panic button on the control	OR
panel or keychain remote will cause the
siren to sound and outgoing calls will
be made to the preprogrammed phone
numbers, “System Panic” will also be
announced. This can be used in any
emergency situation.

To stop the siren and disarm the system, user can enter a valid password, or press the disarm button on the keychain remote. This will terminate the siren and the control panel from calling the rest of the emergency phone numbers.

ARM

PANIC DISARM

AUX

- Control other Skylink receiver such as Garage Door Receiver

System Failure

Control Panel constantly monitors itself and its sensors. If there are any trouble conditions, the control panel will advise the user. These trouble conditions include:

-Phone Line Failure

-Sensor Failure (loss of supervisory signal)

-Low Battery – Control Panel

-Low Battery – Sensors

Phone Line Failure

When the phone line is disconnected or malfunctions, the control panel will instantly notify the user by:

1.Both Power [PWR] and Program [PROG] LEDs will flash together;

2.Voice announcement “Phone Line Failure” will be played.

When phone line failure occurs, please check the phone line connection, ensure the phone line is plugged into both the control panel and the wall socket securely. You should also check the phone line with a normal telephone to determine if it can dial out to a phone number. If it cannot dial out, that indicates the phone line is not in service, you should contact your local phone company.

–23–