Multi-Link ML-100, ML-001 manual Contact ID Phone number, Event Trigger

INSTALLATION

Contact ID Phone number

You can program a telephone number for calling to the central monitoring station. When the system is in panic, the control panel will call this phone number and will send out a Contact ID message with event code 140, which represents “General Alarm”.

HOME AUTOMATION

Event Trigger

You can control up to 5 different devices not only manually, but also automatically. It is called Event Trigger. That means when a sensor is triggered, the control panel will transmit a signal to activate the designated control module. Applications include:

Follow the instructions below to program the necessary info in order to call a monitoring station:

-Phone number of central monitoring station (up to 29 digits)

-Account number given by the Central Monitoring Station

Phone Number Programming (Calling to Central Monitoring Station)

Step	Keys	Function	Description	Note
1	Press [PROG]	Enter Program-	Enter master	3 beeps for valid
	Press [MPIN]	ming mode	password to	password. 1 long
			programming mode	beep for invalid
				password.
2	Press [1]	Select phone		You will hear
		number		[Enter Phone
		programming		Memory]

-Lights on when you open the front door (walking into a room, lights on automatically), this is called "Event Trigger on".

-Lights off when you open a door. (walk away from a room, turns lights off), this is called "Event Triggered off".

Event trigger is only applicable to the sensor(s) and control module in the same zone. For example, you can program control module 1 to be on or off when zone 1 sensor(s) is triggered. You can also program control module 2 to be on / off when zone 2 sensor(s) is triggered.

Factory Default: This feature is disabled for all zones at the factory.

Event Trigger On

Event Trigger Off

3	Press [0]	Enter phone	During emergency,	You will hear
		memory	the Contact ID phone	[Phone Zero]
			number has the highest
			priority, it will be the
			first number to call.
4	Enter [Phone	Enter phone	Phone number	You will hear
	number] +	number	can be up to 29	[Phone Accepted]
	[Arm]		digits.	indicating the phone
				number has been
				programmed
				successfully.

–12–

To change the event trigger setting follow the instructions below.

Step	Keys	Function	Description	Note
1	[PROG]	Enter Program-	Enter master	3 beeps for valid
		ming mode	password to	password. 1 long beep
	[MPIN]
			programming	for invalid password.
			mode
2	[7]	Select Event		After [7] is entered,
		Trigger		some zone LEDs will be
				off, on or flash. This
				indicates the setting of
				event trigger.
3	Disable Event	Select which	Refer to the	If event trigger “ON” is
	Trigger: [1] to	zone you would	diagram below	enabled, that zone LED will
	[5]	like to enable /	to select the	be on. If event trigger “OFF”
		disable event	appropriate	is enabled, that zone LED
	Enable Event	trigger.	setting.	will flash. If it is disabled, the
				zone LED will be off. You are
	Trigger: [6] to
				allowed to make multiple
	[0].
				changes before terminating
				programming mode.
4	[PROG]	Terminate		PROG LED
	when	programming		will be off.
	finished.	mode.

–45–