Content, Operation, Learn Control Modules

g)Should you experience trouble with this equipment, please contact Skylink Customer Support at 1-800-304-1187 for repair or warranty information. If the equipment is causing harm to the telephone network, the telephone company may request that you disconnect the equipment until the problem is resolved.

h)Please follow instructions for repairing if any (e.g. battery replacement section); otherwise do not alternate or repair any parts of device except specified.

i)Connection to party line service is subject to state tariffs. Contact the state public utility commission, public service commission or corporation commission for information.

j)NOTICE: If your home has specially wired alarm equipment connected to the telephone line, ensure the installation of this model AM-002 does not disable your alarm equipment. If you have questions about what will disable alarm equipment, consult your telephone company or a quali- fied installer.

NOTICE: According to telephone company reports, AC electrical surges, typically resulting from lightning strikes, are very destructive to telephone equipment connected to AC power sources. To minimize damage from these types of surges, a surge arrestor is recommended.

CONTENT
Introduction	4
Overview	4
Installation	7
Installing the Console	7
Programming Passwords	9
Phone Number Programming	10
Contact ID Phone number	12
Phone Number Programming (Calling to Central Monitoring Station)	12
Account Number Programming	13
Deactivating the Digital Dialer	14
Installing Door/Window Sensors	15
Installing Motion Sensor	16
Operation	18
Alert mode	18
Mute	19
System Status	20
Arming The System	20
Disarming the system	21
Disarming a triggered control panel	22
Disarming under Duress	22
Panic	23
System Failure	23
Phone Line Failure	23
Sensor Failure	24
Low Battery	24
Coummunication	26
Receiving an emergency call	26
Remote Operation by Telephone	27
To access the control panel away from home	27
Advanced Programming	29
Zone Dependent Setting – Beep / Alarm	29
Zone Dependent Setting – Auto Mute	32
Zone Dependent Setting – Alert Zone (Bypass zone)	33
Learn Keychain / Keypad Remotes	35
Erase Keychain / Keypad Remotes	36
Learn Sensors	37
Sensor Location Selection Guide	37
Erase Sensors	39
Home Automation	40
Learn Control Modules	40
Erase Control Modules	43
Event Trigger	45
Trouble Shooting	47
Accessories	49
System Configuration	53
FCC Information	53
CE	55

–54–

–3–

CONTENT

Operation

Disarming a triggered control panel

Learn Control Modules

System Configuration