Step 5. Optional Wall-Mount Installation
Your Phonecell SX4D may be mounted on a wall. Be sure to test call quality in the selected location before you permanently mount the Phonecell SX4D to the wall.
83 mm
Pre-Installation Tips:
•Make sure the location is dry, away from overhead water pipes, and protected from weather conditions.
•The area should be free of airborne con- taminants.
•The Phonecell SX4D power supply should be located within two meters (six feet) of an AC power outlet.
Wall-Mount Instructions:
1)The Phonecell SX4D comes equipped with a handset mounting clip for wall- mounting applications. Remove the clip from the cradle - see Figures 10 and 11.
2)Insert the handset mounting clip with the tab pointing up - see Figures 10 and 11.
3)To mount the Phonecell SX4D on a wall, mark two hole locations 83 mm (3- 1/4 inches) apart. Use the tick marks on the edge of this page as a template. These hole locations match the mount- ing hooks on the back of the unit - see Figure 9.
4)Using the two hole locations marked above, drill two holes into the wall.
5)Install the screws (not supplied), into the wall,leaving a gap (approximately 3 mm (1/8 inch)) between screw head and wall.
6)Mount the Phonecell SX4D onto the screws - see Figure 12.
Figure 12
SX4D GSM 900 • SX4D GSM 1800 | 17 |
83 mm (3-1/4 inches)
Mounting | Battery | Battery |
Hooks | Access | Access |
| Door | Door Tab |
Figure 9 – Phonecell SX4D mounting hooks and battery access door located on the back of the unit.
Insert
Mounting
Clip into the Cradle
Remove(tab up) Mounting
Clip from the Cradle (tab down)
Figure 10 – Handset mounting clip assembly for wall-mount applications.
Mounting
Clip in
Cradle (tab up)
Figure 11 – Handset mounting clip assembly.
USER MANUAL