Telular SX4D How to Place a Call, How to Receive a Call, How to End a Call, Hookflash Function

Phonecell Operation - continued

How to Place a Call

1)Pick up your Phonecell SX4D handset (your phone is now “off-hook”).

2)Listen for dial tone (If service is not available, a No-Service tone is produced and the letter “N” is displayed on the LCD in the Alpha (bottom) row. Hang-up the Phonecell SX4D and try again. If the No-Service tone continues and the “N” continues to be displayed, contact your service provider to make sure cellu- lar service is activated.).

3)Dial the phone number.

How to Receive a Call

•When your Phonecell SX4D rings, pick up the handset and begin talking.

How to End a Call

•Hang-up the phone (place the handset back onto the Phonecell SX4D cradle).

The Hookflash Function

When you initiate the Hookflash function, it automatically lets you:

•Speed up the connection after you dial a phone number.

•Answer an incoming call that occurs when you’re dialing a phone number.

•Use special (supplementary) cellular services which may be available in your cellular service area.

How to Use the Hookflash Function

There are two ways to initiate the Hookflash function:

•Press the “FLASH” key on your Phonecell SX4D.

•Press the hang-up or switch-hook mechanism on your Phonecell SX4D once quickly (approximately 1/2-second).

Important Tones and Alerts

No-Service Tone – When cellular service is not available, the receiver emits a No-Service (fast-beeping)tone instead of the normal (steady) dial tone.

ROH (Receiver Off-Hook) Tone – If the Phonecell SX4D handset remains off- hook (off its cradle) with no dialing activity for 30 seconds, the receiver emits an ROH tone for 45 seconds.

Incoming Call Alert – If you’re dialing a number and an incoming call occurs, the receiver will emit an audible ring. To answer the incoming call:

•Press the “FLASH” button once. This will connect the incoming call.

•OR hang-up immediately. This will cause the phone to start ringing.

Roam Dial Tone – When cellular service is available, but the Phonecell SX4D is in a Roam area, the receiver may emit a different dial tone to indicate the roaming condition. However, unless the Phonecell SX4D is re-programmed in the field, the factory default tone is set the same as normal service dial tone.

SX4D GSM 900 • SX4D GSM 1800 23 USER MANUAL