Motorola XTNi Series manual Batteries and Chargers

Page 17

Alkaline Battery Pack (optional accessory) Removing Alkaline Batteries Installing Alkaline Battery

BATTERIES AND CHARGERS

1.Turn OFF the radio, if it is turned ON.

2.Remove Li-Ion battery

3.Assemble alkaline battery pack (optional accessory) in the same steps as installing the Li-Ion battery pack.

4.Remove battery door from alkaline battery pack.

5.Slide the 5 AA alkaline batteries into the frame, matching the markings inside the compartment.

1.Turn OFF the radio, if it is turned ON.

2.Slide the battery latches, on both sides of the battery, downwards.

3.Pull the top of the battery away from the radio’s body, and lift the battery from the radio’s body.

15English

Image 17
Contents Page Page Contents Getting Started Programming FeaturesContents AccessoriesComputer Software Copyrights Computer Software CopyrightsSafety SafetyBatteries and Chargers Safety Information Batteries and Chargers Safety InformationOperational Safety Guidelines Radio Radio OverviewParts of the Radio Radio Overview Side Buttons Lithium-Ion Li-Ion BatteryModel Frequency Transmit Power Number Antenna Band About the Li-Ion Battery Battery Features and Charging Options Batteries and Chargers Batteries and ChargersBattery Recycling and Disposal Battery Latchbattery latch Slots Turn OFF the radio Batteries and Chargers Power Supply, Adaptors and Drop-in Tray Charger Install RemoveBattery Life Information Installing Spring Action Belt ClipFollowing chart summarizes battery life estimations Charging with the Drop-in Tray Single Unit Charger Charging the BatteryCharging a Stand-Alone Battery Charging a Standard Battery Adjustable bracket Standard High and Ultra High Capacity Charging a High Capacity Battery Standard Charger LED Indicator Drop-in Tray Charger LED IndicatorsEstimated Charging Time MUC LED Indicator Getting Started Adjusting VolumeGetting Started Turning Radio ON/OFFReceiving a Call Selecting a ChannelTalking and Monitoring Talk Range Signal Strength Indicator and Channel Busy IndicatorsGetting Started Radio Status LED Indication Getting Started Radio LED IndicatorsHANDS-FREE USE/VOX With Compatible VOX AccessoriesReset To Factory Defaults Hands Free without Accessories iVOXBattery Save End of Transmission Tone Roger Beep Tone Setting VOX/iVOX SensitivityKeypad Beeps Menu OptionsIVO Setting VOX / iVOX sensitivityStarted GettingImic YES Entering Programming Mode Programming FeaturesProgramming RX Reception Codes CTCSS/DPL Programming FeaturesProgramming RX Reception Frequencies Programming RX Reception Bandwidth RX BWProgramming Maximum Number of Channels Programming Scramble LProgramming Call Tones MA X CHProgramming Microphone Gain Level Programming Scan List YESProgramming Buttons Editing Channel Alias Name Nuisance Channel Delete Bandwidth Select Time-Out TimerCPS Computer Programming Software Scramble Battery Type SettingCall Tones Cloning with a Multi-Unit Charger MUC Programming Features Cloning RadiosTurn on the Target radio and place it Into one of the SUCs What to do if cloning fails Cloning Radios using the CPS Computer Programming Software Troubleshooting TroubleshootingDoes not come on Cannot activate VOX USE and Care USE and CareIf the radio is submerged in water Channel Radios PMR 446 Defaults Frequency and Code ChartsFrequency and Code Charts Ctcss DPL Codes 108 627 115 712 Warranty Information WarrantyWhat is not Covered by the Warranty Motorola LimitedMotorola Limited Warranty Accessories Chargers Page 6871663M05