Getting started
Battery installation and charging
Install the battery as shown below. The battery may have enough charge for short calls. For best performance, charge the handset for at least 16 hours. When the battery power is low, the handset will beep, display LOW BATTERY and will flash on the handset screen. Place the handset in the telephone base to charge the battery when not in use. When fully charged, the handset battery provides approximately nine hours of talk time or five days of standby time.
1.Insert the plug of the battery as indicated. Make sure it is plugged securely and matches the
2.Place the battery with the label THIS SIDE UP facing up and the wires inside the battery compartment.
3.Align the cover flat against the battery compartment, then slide it upwards until it clicks into place.
4.Charge the handset by placing it in the telephone base. The handset charge
light will be on when charging.
1 | 2 | 3 | 4 |
•If the handset will not be used for a long time, disconnect and remove the battery to prevent possible leakage.
•To purchase a replacement battery, visit our website at www. vtechphones. com or call
1 (800)
Getting started Basic operation
www.vtechphones.com