VTech CS6124-31, CS6124-21, CS6124-11 user manual FCC, Acta and IC regulations, FCC Part

Page 49

Appendix

FCC, ACTA and IC regulations

FCC Part 15

This equipment has been tested and found to comply with the requirements for a Class B digital device under Part 15 of the Federal Communications Commission (FCC) rules. These requirements are intended to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications to this equipment not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Privacy of communications may not be ensured when using this telephone.

To ensure safety of users, the FCC has established criteria for the amount of radio frequency energy that can be safely absorbed by a user or bystander according to the intended usage of the product. This product has been tested and found to comply with the FCC criteria. The handset may be safely held against the ear of the user. The telephone base shall be installed and used such that parts of the user’s body other than the hands are maintained at a distance of approximately 20 cm (8 inches) or more.

This Class B digital apparatus complies with Canadian ICES-003.

FCC Part 68 and ACTA

This equipment complies with Part 68 of the FCC rules and with technical requirements adopted by the Administrative Council for Terminal Attachments (ACTA). The label on the back or bottom of this equipment contains, among other things, a product identifier in the format US:AAAEQ##TXXXX. This identifier must be provided to your telephone service provider upon request.

The plug and jack used to connect this equipment to premises wiring and the telephone network must comply with applicable Part 68 rules and technical requirements adopted by ACTA. A compliant telephone cord and modular plug is provided with this product. It is designed to be connected to a

compatible modular jack that is also compliant. An RJ11 jack should normally be used for connecting to a single line and an RJ14 jack for two lines. See Installation Instructions in the user’s manual. The Ringer Equivalence Number (REN) is used to determine how many devices youAppendixmay connect to

your telephone line and still have them ring when you are called. The REN for this product is encoded as the 6th and 7th characters following the US: in the product identifier (e.g., if ## is 03, the REN is

0.3). In most, but not all areas, the sum of all RENs should be five (5.0) or less. For more information, please contact your telephone service provider.

This equipment may not be used with Party Lines. If you have specially wired alarm dialing equipment connected to your telephone line, ensure the connection of this equipment does not disable your alarm equipment. If you have questions about what will disable alarm equipment, consult your telephone service provider or a qualified installer.

45

Page 48 Page 50
Image 49
Page 48 Page 50
Contents Online user’s manual Congratulations Table of contents Index Appendix Display screen messages Handset and telephone baseGetting started Parts checklistWall mounting optional Telephone base and charger installationBattery charging Battery installationCharge light Handset layoutMENU/SELECT Delete Telephone base layoutUsing the menu Telephone settingsRinger volume telephone base Ringer volume handsetLCD language To manually turn off these indicatorsClear voicemail To select a languageKey tone To change the settingSet date and time Set date/time, then press MENU/SELECTHome area code Dial modeWebsite Telephone operation Temporary tone dialing Temporary ringer silencingFind handset Chain dialing Multiple handset use for multi-handset models onlyReview and dial from the redial list Redial listDelete a redial entry DirectoryAdd a directory entry Alphabetical search Review and dial from the directoryTo start an alphabetical search Review. Press MENU/SELECT againDelete a directory entry Edit a directory entryCall log About caller IDInformation about caller ID with call waiting Memory match Missed call indicatorReview and dial from the call log Save a call log entry to the directory View dialing optionsCall log display screen messages Delete the call log entriesAnswering system setup Answering system settingsAnswer ON/OFF Call screeningNumber of rings Remote access codeMessage alert tone Voice language Recording timeRecord your own announcement AnnouncementPlay or delete your own announcement Answering system and voicemail Answering system operationMessage capacity Call intercept New message indicationMessage playback To play messages with the telephone baseRecord, play or delete memos Delete all messagesTo delete all messages with the telephone base To delete all messages with a handsetWindow display Description Message window displaysCommand Function Remote accessDisplay screen messages AppendixHandset screen icons Handset and telephone base indicatorsHandset light Telephone base lightBattery needs charging when BatteryMy telephone does not work at all TroubleshootingThere is no dial tone Cannot dial outTelephone does not ring when there is an incoming call Low battery shows on the handset screenCharge light is off My handset beeps and is not performing normallyMy caller ID features are not working properly Hear other calls when using the telephoneHear noise on the cordless handset and the keys do not work Cannot retrieve voicemail messages Out of range or no pwr at base shows on the handset screenAnswering system does not record messages Outgoing announcement is not clearCannot hear any messages from the handset Messages on the answering system are very difficult to hearCommon cure for electronic equipment Answering system does not respond to remote commandsImportant safety instructions Maintenance Precautions for users of implanted cardiac pacemakersOperating range Rbrc seal About cordless telephonesWhat does this limited warranty cover? Limited warrantyHow do you get warranty service? FCC Part FCC, Acta and IC regulationsIndustry Canada Technical specificationsIndex Index All rights reserved. Version 7 03/12
Related manuals
Manual 2 pages 22.92 Kb Manual 53 pages 30.98 Kb
Top Page Image Contents