VTech CS6124-21, CS6124-11, CS6124-31 user manual Appendix, Display screen messages

Page 35

Appendix

Display screen messages

Annc deleted	Your recorded announcement is deleted.
Call log empty	There are no call log entries.
Directory empty	There are no directory entries.
Directory full	The directory is full.
Ended X:XX:XX	You have just ended a call.
Incoming call	There is an incoming call.
Line in use	A system handset or another telephone on the same line is in use.
Low battery	The battery needs to be recharged.
Microphone on	MUTE is turned off and the person on the other end can hear you.
Muted	You have turned off the handset microphone. The other party cannot
	hear you but you can hear the other party.
New voicemail	There are new voicemail message(s) from the telephone service
	provider.
No battery	No battery is installed. Follow the directions for battery installation on
	page 3 to install the battery before charging.
No line	There is no telephone line connected.
No message	There are no messages in the answering system.
No signal	Communication between the handset and the telephone base is lost
	during a call.
Not available	One handset is reviewing the call log and the other handset tries to
	review it; or one handset is accessing the answering system and the
	other handset tries to access it.
Not registered	The handset may be deregistered from the telephone base. Follow the
	instructions on page 34 to register the handset to the telephone base.
Number repeated	The telephone number entered is already stored in the directory.
Out of range or	The handset cannot communicate with the telephone base. Check the
no pwr at base	telephone base power connection or move the handset closer to the
	telephone base.
Phone X:XX:XX	The handset is on a call.
Place in charger	The battery is very low. Place the handset in the telephone base or
	charger for recharging.
Rec mem full	The answering system has no recording time left.	Appendix
Rec mem full	The answering system has no recording time left.
Rec mem low	The answering system has less than three minutes recording time left.
Record in X sec	You can record your own announcement or memo after the tone
	is played.
Ringer muted	The handset ringer is muted temporarily during an incoming call.
Ringer off	The handset ringer is turned off.
Saved	Your selection has been saved.
XX missed calls	There are calls that have not been reviewed in the call log.
XX new messages	There are new messages in the answering system.
Paging	All system handsets are being paged.

31

Image 35

Contents Online user’s manual Congratulations Table of contents Index Appendix Display screen messages Handset and telephone baseGetting started Parts checklistWall mounting optional Telephone base and charger installationBattery charging Battery installationCharge light Handset layoutMENU/SELECT Delete Telephone base layoutRinger volume handset Telephone settingsUsing the menu Ringer volume telephone baseTo select a language To manually turn off these indicatorsLCD language Clear voicemailSet date/time, then press MENU/SELECT To change the settingKey tone Set date and timeWebsite Dial modeHome area code Telephone operation Find handset Temporary ringer silencingTemporary tone dialing Chain dialing Multiple handset use for multi-handset models onlyDirectory Redial listReview and dial from the redial list Delete a redial entryAdd a directory entry Review. Press MENU/SELECT again Review and dial from the directoryAlphabetical search To start an alphabetical searchDelete a directory entry Edit a directory entryInformation about caller ID with call waiting About caller IDCall log Review and dial from the call log Missed call indicatorMemory match Save a call log entry to the directory View dialing optionsCall log display screen messages Delete the call log entriesCall screening Answering system settingsAnswering system setup Answer ON/OFFMessage alert tone Remote access codeNumber of rings Voice language Recording timePlay or delete your own announcement AnnouncementRecord your own announcement Message capacity Answering system operationAnswering system and voicemail To play messages with the telephone base New message indicationCall intercept Message playbackTo delete all messages with a handset Delete all messagesRecord, play or delete memos To delete all messages with the telephone baseWindow display Description Message window displaysCommand Function Remote accessDisplay screen messages AppendixTelephone base light Handset and telephone base indicatorsHandset screen icons Handset lightBattery needs charging when BatteryCannot dial out TroubleshootingMy telephone does not work at all There is no dial toneMy handset beeps and is not performing normally Low battery shows on the handset screenTelephone does not ring when there is an incoming call Charge light is offHear noise on the cordless handset and the keys do not work Hear other calls when using the telephoneMy caller ID features are not working properly Cannot retrieve voicemail messages Out of range or no pwr at base shows on the handset screenMessages on the answering system are very difficult to hear Outgoing announcement is not clearAnswering system does not record messages Cannot hear any messages from the handsetCommon cure for electronic equipment Answering system does not respond to remote commandsImportant safety instructions Operating range Precautions for users of implanted cardiac pacemakersMaintenance Rbrc seal About cordless telephonesWhat does this limited warranty cover? Limited warrantyHow do you get warranty service? FCC Part FCC, Acta and IC regulationsIndustry Canada Technical specificationsIndex Index All rights reserved. Version 7 03/12

Related manuals

Manual 2 pages 22.92 Kb

Manual 53 pages 30.98 Kb