VTech VT 2960 instruction manual Important Safety Instructions

Page 5

IMPORTANT SAFETY INSTRUCTIONS

XII. Unplug this product from the wall outlet :

A.When the power supply cord or plug is damaged or frayed.

B.If liquid has been spilled into the product.

C.If the product has been exposed to rain or water.

D.If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions, because improper adjustment of other controls may result in damage and will often require extensive work to restore the product to normal operation.

E.If the product has been dropped and the cabinet has been damaged.

F.If the product exhibits a distinct change in performance.

XIII.Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of electric shock from lighting.

XIV.Do not use the telephone to report a gas leak in the vicinity of the leak.

SAVE THESE INSTRUCTIONS

5

Image 5
Contents Introduction 900MHz Operation Special FeaturesLine OFF Parts Check ListImportant Safety Instructions Important Safety Instructions To Charge The Battery Pack Rechargeable Battery PacksSpare Battery Charger Charging the Handset batteries267-7377in Canada Replacing The Handset Battery PackUse only Vtech battery Position the wall mounting bracket on the Base Wall MountingHandset Features Line 2 KEY Line 1 KEYOFF KEY Tone KEYHOLD/PAUSE KEY Redial KEYCONFERENCE/CLEAR CONF/ Clear KEY Line 2 is on a call and Line 1 is onVolume Control KEY Examples of the LCD Display Examples of the LCD Display Examples of the LCD Display Base Unit Features Base Unit FeaturesSpare Battery LED Base LED Indicators Power LEDCharge LED Intercom LEDTONE/PULSE Switch Volume UP & Down KeysConf KEY Hold KEYGetting Started Setting up your VTech VTPreference Connect the telephone line cordsMaking Calls Basic OperationsTo put a call on Hold from the Handset Press the HOLD/PAUSE key to place a call on HoldHandset Base Unit Speakerphone Answering Calls fromSwitching from Handset to Base Unit Speakerphone Switching from Handset to Base or Base to HandsetSwitching from Speakerphone to Handset Call WaitingHandset Paging Base Unit Basic OperationBase Unit Paging Handset Programming the Ringer Advanced OperationsConference Calls Memory Dialing Programming the Base Unit RingerCation RedialChanging Stored Numbers Speed Dial LocationTo delete all phone numbers stored in Memory Delete ALL? DEL to AllowCharacters, including spaces CID-CALLER IDCall is displayed Examples of Caller ID DisplaysDeleting a single CID record Deleting CID RecordsDeleting Single Call Deleting ALL CID recordsProgram Location VT2960 Answering System Setting ANNOUNCE-ONLY Mode Call Screening Setting the Number of RingsNumber of Rings selected is Audible Message Alert R e s s S T O P / P L AY t o e x i t programming modeSetting the DAY and Time Selecting Lines for Message Playback VolumePlay SkipAdvanced Functions Memo RecordingBasic Functions Installation Headset Installation and Operating InstructionsPlug the Optional Headset IntoMaintenance Taking Care of Your Telephone MaintenanceCase of Difficulty Handset does not Ring When YOU Receive a CallPhone DOESN’T Work AT ALL No Dial ToneMake sure the power cord is plugged YOU Hear Other Calls While Using Your PhoneCommon Cure for Electronic Equipment Found ChannelWarranty Statement What does OUR Warranty not COVER? United States FCC and IC RegulationsVtech Communications Canada Vtech Electronics FCC PartFCC and IC Regulations This telephone is registered for use in Canada IC Industry CanadaSpecifications Table of Contents Headset Installation and Operating Instructions Maintenance Issue