Cisco Systems 509G manual Number Option

Using Advanced Phone Features	4
Using the Interactive Voice Response Menu on the Cisco SPA 501G

Typical options you might use are listed in the following table:

Number	Option
100	Tells you if Dynamic Host Configuration Protocol (DHCP) is enabled.
110	Recites the IP address of the phone.
120	Recites the netmask of the phone.
130	Recites the gateway address.
140	Recites the MAC (hardware) address of the phone.
150	Recites the phone software version.
160	Recites the primary DNS server address.
170	Recites the HTTP port on which the web server listens. Defaults to 80.

180Recites the IP multicast address (used by the Cisco SPA 9000 to communicate with the IP phone).

220Recites the method of call control (SIP or SPCP).

221Set call control—enter the value for the call control method you want, then press #:

•0: SIP

•1: SPCP

To save, press 1; to review, press 2; to re-enter, press 3; to exit, press *.

73738	Restore the phone to the factory default software and settings.
	Enter 1 to confirm, or * to exit. If you chose to reset, hang up to exit and
	begin the restore process.
87778	Restore the phone’s user settings to the default. (Clears all user settings
	such as speed dials.)
	Enter 1 to confirm, or * to exit. If you chose to reset, hang up to exit and
	begin the restore process.

732668

Reboot the phone. After entering #, hang up to begin rebooting.

Cisco Small Business Pro IP Phone SPA 50X User Guide (SIP) 63