Cisco Systems DVC-1000 manual Main Screen Settings Update

Page 31

Using the Configuration Menu (continued)

Main Screen > Settings > Update

The Update screen has several functions:

Set the checkbox to automatically check for updates of the DVC- 1000 VideoPhone.

Check for an update right now.

Display the current version information.

Set Defaults will restore all settings to factory defaults. This will erase all speed dial entries that have been added.

If you select Check Now for an Update then the DVC-1000 will check for an update. If an update is found the following message will appear.

Clicking YES will begin an update of the firmware in the DVC-1000. A
restart of the DVC-1000 is required after the update is complete.	31
	31

Image 31

Contents I2 eyeTM Contents Introduction System Requirements Package ContentsConnections Features & BenefitsLED LEDsGetting Started Using the Remote ControlSpeakerphone Mode Adjust Contrast Remote Control LayoutUsing the On-Screen Keyboard Welcome Screen Using the Setup WizardPersonal Information Screen IP Address, Subnet mask, Gateway Using the Setup WizardObtain an IP Address automatically Default Network Address ScreenNetwork Speed Screen DNS Domain Naming System ScreenSystem Restart Using a Telephone with the DVC-1000Status Icons Using the DVC-1000Audio Video Do Not Disturb Using the DVC-1000Privacy Status Icons Answering an Incoming VideoPhone callPlacing a Manual Dial VideoPhone Call Using the Remote Speakerphone Mode Entering Phone Numbers Using the DVCEntering IP Addresses Dial Using the Configuration MenuSettings Main ScreenManual Dial Using the Configuration MenuMain Screen Dial Speed Dial ListRemove Edit Close AddDisplay Connection Default ViewMain Screen View Full Screen ViewUpdate Main Screen SettingsGeneral Personal Information Network Turn on video privacy when answering calls Main Screen Settings GeneralAlways answer incoming calls Name Main Screen Settings Personal InformationAddress Main Screen Settings NetworkPublic IP Speed IP Address Subnet mask Gateway Main Screen Settings Network Address Primary DNS Secondary DNS Main Screen Settings Network DNSUse Private IP Address Specify public IP Public IP address Main Screen Settings Network Public IP AddressMain Screen Settings Network Network Speed Main Screen Settings Update Audio Privacy Main Screen PrivacyVideo Privacy Do not Disturb Upgrades Opening Ports on Your Routers and Gateways Click Enabled How to open ports on a routerUnder Private Port and Public Port , enter Opening Ports on Your Routers and Gateways Broadband Modem and One PC Network With Multiple Public IP AddressesBroadband Modem, Multiple PCs and a Router Broadband Modem, Multiple PCs and a HubBroadband Modem Only Cannot make direct IP calls TroubleshootingCannot make a call using a phone number Error Message displays on main screenTelephone doesn’t ring with an incoming call TroubleshootingVideoPhone freezes-up while answering a call Poor video in a call No video in a callNo audio in call Video freezes during a callAudio stops during a call Excessive delay during a conversationAudio has a echo VideoPhone reports packet loss Error Displays on main screenPublic IP button is not enabled VideoPhone cannot obtain IP Address automaticallyIncorrect Network Speeds Video is not being displayed on television VideoPhone does not boot upWhat is D-Link´s i2eye? Frequently Asked QuestionsWhat is the D-Link Ldap Directory Service? Frequently Asked Question What standards drive i2eye? What devices can I connect to with the DVC-1000?Do I have to take every call? Glossary of Terms Glossary of Terms Between network devices over a network Technical Specifications Technical Specifications Technical Support Contacting Technical SupportWarranty and Registration Statutory 02/28/2003