Patton electronic manual SN4940 model codes, SN4941 model codes

Page 15

SmartNode 4940 Getting Started Guide	1 • General information

SN4940 model codes

The SmartNode 4940 series consists of several models. They differ in the number of PRI ports and voice chan- nels supported. All models come equipped with one 10/100/1000Base-T Ethernet port. The SmartNode 4940 PRI ports and voice channels are listed in table 2.

Table 2. SmartNode 4940 PRI Ports and Voice Channels

Model	PRI Ports	Voice Channels

SN4940/1E24V/EUI	1	24
SN4940/1E30V/EUI	1	30

SN4940/4E24V/EUI	4	24
SN4940/4E30V/EUI	4	30

SN4940/4E48V/EUI	4	48
SN4940/4E60V/EUI	4	60

SN4940/4E96V/EUI	4	96
SN4940/4E120V/EUI	4	120

SN4941 model codes

The high precision SmartNode 4941 models have a Stratum III clock. The Stratum III clock provides a clock source of < 5 ppm. For PBXs that used to rely on PSTN for accurate clock source, the SmartNode 4941 can provide a PSTN-equivalent high precision clock. The popular DECT PBX needs such high precision clocks.

Note For high precision clock models, replace SN4940 with SN4941 in the model code.

SmartNode 4940 overview

15

Image 15

Contents SmartNode 4940 Series Mailsupport@patton.com Summary Table of Contents Table of Contents Contacting Patton for assistance Cabling List of Figures List of Tables About this guide AudienceStructure Impaired functioning PrecautionsSafety when working with electricity Typographical conventions used in this document General observations General conventions General information Chapter contentsSmartNode SmartNode 4940 overviewSN4941 model codes SN4940 model codesSmartNode 4940 rear panel ports are described in table SmartNode 4940 rear panelDC power input SN4940/4E120V SmartNode 4940 front panelLED Applications overview Application-Convert Legacy PBX to VoIP IntroductionSmartNode installation Network information Planning the installationNetwork Diagram Site logInstalling the gateway Connecting the PRI Connecting the power supply Initial configuration Configuring the desired IP address Connecting the SmartNode to the networkFactory-default IP settings Connecting the SmartNode to the network Loading the configuration optionalStart Bootloader BootloaderLoad a new application image SmartWare via Tftp Start-up with factory configurationCopy tftp//tftpserveraddress/server path/b1 flash Load a new application image SmartWare via the serial link Additional informationContacting Patton for assistance Warranty coverage Contact informationPatton support headquarters in the USA RMA numbers Out-of-warranty serviceAppendix a Compliance information Pstn Regulatory SafetyCompliance Radio and TV InterferenceIndustry Canada Notice FCC Part 68 Acta StatementAuthorized European Representative CE Declaration of ConformityAppendix B Specifications Fax and modem support Voice processing signalling dependentVoice connectivity Data connectivityVoice signalling IP servicesVoice routing-session router Management SystemPhysical SmartNode Model SysObjectID Identification of the SmartNode devices via SnmpSmartNode Model SysObjectID Appendix C Cabling Console Connecting a serial terminalEthernet E1 PRI T1 PRI Appendix D Port pin-outs Console port Pin SignalPRI port Appendix E SmartNode 4940 factory configuration Introduction Appendix F End user license agreement End User License Agreement Other licenses Termination