Patton electronic 4940 manual Connecting the power supply

Page 26

SmartNode 4940 Getting Started Guide	3 • SmartNode installation

Connecting the power supply

•Do not connect power to the AC Mains at this time.

•The external power adapter shall be a listed Limited Power

WCAUTIONRNING Source.

•The 4940 external power supply automatically adjusts to accept an input voltage from 100 to 240 VAC (50/60 Hz). Verify that the proper voltage is present before plugging the power cord into the receptacle. Failure to do so could result in equipment damage.

1.Insert the barrel type connector end of the AC power cord into the external power supply connector (see figure 5).

2.Insert the female end of the power cord into the internal power supply connector.

–

+ 12V, 1.25A

Power

T1/E1

T1/E1
Ports 0-3	ETH	0

ETH 0 10/100/1000Base-T port

t e s e R

Console RS-232

	RESET	Console
		RS-232 port
	button

Figure 5. Power connector location on rear panel

3.Verify that the AC power cord included with your router is compatible with local standards. If it is not, refer to chapter 5, “Contacting Patton for assistance” on page 32 to find out how to replace it with a com- patible power cord.

4.Connect the male end of the power cord to an appropriate power outlet.

5.Verify that the green Power LED is lit (see figure 5).

Installing the gateway

26

Image 26

Contents SmartNode 4940 Series Mailsupport@patton.com Summary Table of Contents Table of Contents Contacting Patton for assistance Cabling List of Figures List of Tables Structure About this guideAudience Precautions Impaired functioningSafety when working with electricity General conventions Typographical conventions used in this documentGeneral observations Chapter contents General informationSmartNode 4940 overview SmartNodeSN4940 model codes SN4941 model codesSmartNode 4940 rear panel SmartNode 4940 rear panel ports are described in tableDC power input SmartNode 4940 front panel SN4940/4E120VLED Applications overview Introduction Application-Convert Legacy PBX to VoIPSmartNode installation Site log Planning the installationNetwork Diagram Network informationInstalling the gateway Connecting the PRI Connecting the power supply Initial configuration Factory-default IP settings Configuring the desired IP addressConnecting the SmartNode to the network Loading the configuration optional Connecting the SmartNode to the networkBootloader Start BootloaderStart-up with factory configuration Load a new application image SmartWare via TftpCopy tftp//tftpserveraddress/server path/b1 flash Additional information Load a new application image SmartWare via the serial linkContacting Patton for assistance Patton support headquarters in the USA Warranty coverageContact information Out-of-warranty service RMA numbersAppendix a Compliance information Radio and TV Interference SafetyCompliance Pstn RegulatoryFCC Part 68 Acta Statement Industry Canada NoticeCE Declaration of Conformity Authorized European RepresentativeAppendix B Specifications Data connectivity Voice processing signalling dependentVoice connectivity Fax and modem supportVoice routing-session router Voice signallingIP services Physical ManagementSystem Identification of the SmartNode devices via Snmp SmartNode Model SysObjectIDSmartNode Model SysObjectID Appendix C Cabling Connecting a serial terminal ConsoleEthernet E1 PRI T1 PRI Appendix D Port pin-outs Pin Signal Console portPRI port Appendix E SmartNode 4940 factory configuration Introduction Appendix F End user license agreement End User License Agreement Termination Other licenses