Patton electronic 4940 manual Led

Page 19

SmartNode 4940 Getting Started Guide1 • General information

	Table 4. SN4940 Front and Rear panel LEDs

LED	Description

Note	If an error occurs, all LEDs will flash once per second.
Power	When lit, indicates power is applied.

Run	When lit, the unit is in normal operation. Flashes once per second during
	boot (startup).
VoIP Link	• On indicates the gateway is registered to an H.323 gatekeeper/SIP server, or,
	in the case of direct routing, has at least one active VoIP connection.
	• Off indicates the unit is not configured or registered, or has no active direct-
	routed VoIP connection.
	• Flashing green indicates that the unit is attempting to register or has failed
	to register.

Ethernet Link	• On when the Ethernet connection on the corresponding port has a
	link indication.
Ethernet Speed	When the Ethernet Link LED is on, then:
10/100	• On when the Ethernet is connected to a 100Mb network.
	• On when the Ethernet is connected to a 100Mb network.
	• Off when the Ethernet is connected to a 10Mb network.

Ethernet Speed	• On when the Ethernet is connected to a 1000Mb network.
1000
Ethernet Activity	• Flashes when data is received or transmitted at the corresponding Ethernet port.

PRI Link/Status	• On = in frame, no errors
	• Flash = Error
	• Fast Flash = Signal detected but no frame synchronization or aquisition is in
	process
	• Slow Flash = Framing synchronized, Signaling not established

SmartNode 4940 front panel

19

Image 19

Contents SmartNode 4940 Series Mailsupport@patton.com Summary Table of Contents Table of Contents Contacting Patton for assistance Cabling List of Figures List of Tables Audience About this guideStructure Impaired functioning PrecautionsSafety when working with electricity General observations Typographical conventions used in this documentGeneral conventions General information Chapter contentsSmartNode SmartNode 4940 overviewSN4941 model codes SN4940 model codesSmartNode 4940 rear panel ports are described in table SmartNode 4940 rear panelDC power input SN4940/4E120V SmartNode 4940 front panelLED Applications overview Application-Convert Legacy PBX to VoIP IntroductionSmartNode installation Network information Planning the installationNetwork Diagram Site logInstalling the gateway Connecting the PRI Connecting the power supply Initial configuration Connecting the SmartNode to the network Configuring the desired IP addressFactory-default IP settings Connecting the SmartNode to the network Loading the configuration optionalStart Bootloader BootloaderLoad a new application image SmartWare via Tftp Start-up with factory configurationCopy tftp//tftpserveraddress/server path/b1 flash Load a new application image SmartWare via the serial link Additional informationContacting Patton for assistance Contact information Warranty coveragePatton support headquarters in the USA RMA numbers Out-of-warranty serviceAppendix a Compliance information Pstn Regulatory SafetyCompliance Radio and TV InterferenceIndustry Canada Notice FCC Part 68 Acta StatementAuthorized European Representative CE Declaration of ConformityAppendix B Specifications Fax and modem support Voice processing signalling dependentVoice connectivity Data connectivityIP services Voice signallingVoice routing-session router System ManagementPhysical SmartNode Model SysObjectID Identification of the SmartNode devices via SnmpSmartNode Model SysObjectID Appendix C Cabling Console Connecting a serial terminalEthernet E1 PRI T1 PRI Appendix D Port pin-outs Console port Pin SignalPRI port Appendix E SmartNode 4940 factory configuration Introduction Appendix F End user license agreement End User License Agreement Other licenses Termination