AT&T E1126, E2126 user manual Wall mounting, Plug telephone line cord into telephone cord wall jack

Getting Started

Wall mounting

The base can be installed on any standard phone outlet as shown below. Choose a loca- tion in a central location within the home, away from electronic equipment such as per- sonal computers, computer routers, television sets or microwave ovens. Avoid excessive heat, cold, dust or moisture.

1)Connect telephone line cord and AC power cord to telephone jacks and wall jacks, as shown on

page 6.

2) Install wall mount bracket onto set. First put the two front wall-mount-bracket tabs into the front notches on bottom of tele- phone base, then squeeze the rear tabs of the wall mount bracket as you insert them into the rear notches on the bottom of the telephone base.

NOTE: To disassemble the wall mount bracket, squeeze the rear

tabs while lifting up the wall mount bracket back and away from the telephone base.

Plug power adapter into electrical outlet.

3) Position the wall- mount bracket over the wall-outlet mounting pegs, and press and slide the wall-mount bracket down firmly so it is held securely on the outlet mounting pegs.

Plug telephone line cord into telephone cord wall jack.

8