AT&T 9351 user manual Mount the base on the wall, Follow Steps 3-5 in Table/Desk Installation

Page 8

9351_book_2ATT 1/1/01 3:33 PM Page 6

INSTALLATION

4 Mount the base on the wall.

a) Align holes on base with mounting studs on wall jack.

b)Place power cord as shown, so it hangs straight down between base and wall.

c)Pull base down on mounting studs until it locks into place.

5 Follow Steps 3–5 in “Table/Desk Installation.”

6

Image 8
Contents Revised Part 1 Important Product InformationAdvanced American Telephones. All rights reserved Contents Install the handset battery InstallationBefore You Install Attach the belt clip to the cordless handset optional Table/Desk Installation Charge the handset batterySet the dial mode Check for dial tonePosition the wall mount adapter on the base Wall InstallationConnect the telephone line cord Connect the power cord Follow Steps 3-5 in Table/Desk Installation Mount the base on the wallTelephone Operation Page/Handset Locator Ringer Off Temporary Tone DialingHandset Ringer Style Headset Jack Operating RangeTelephone Memory Audible Indicators Answering System OperationAbout Mailboxes About AnnouncementsRecord Your Announcement Press Uuntil you hear Set Outgoing MessageAnswering System Feature Setup Feature SummaryAdjust Playback Volume Listen To, Save & Delete MessagesDelete Messages Play MessagesMessage Window Display Call Screening/InterceptRecord a Memo Connect with the Answering System Voice MenuRemote Access Commands Charging the Handset Battery Pack BatteriesReplacing the Handset Battery Pack Spare Battery Charger Spare battery compartmentIf the phone doesn’t work at all, check these items first If the phone does not ring when you receive a callCase of Difficulty If you hear noise or interference when using the phone If you hear other calls while using your phoneIf you lose a call after changing channels If messages are incompleteIf your outgoing announcement isn’t clear If you have difficulty hearing messagesIf CL appears in the Message Window