AT&T 9351 user manual Table/Desk Installation, Charge the handset battery, Check for dial tone

Page 6

9351_book_2ATT 1/1/01 3:33 PM Page 4

INSTALLATION

Table/Desk Installation

Standard

Modular

electrical outlet

telephone

jack

1Connect the telephone line cord.

2Connect the power cord. The ANSWER ON/OFF light goes on, and CL flashes in the Message Window.

Use only the power cord supplied with this product. If you need a replacement, call 1 800 222-3111.

3Charge the handset battery.

Place the handset in the base. Charge the battery for at least 24 hours the first time. After the first charge, the battery is typically fully charged overnight.

4Check for dial tone.

After the batteries are charged, pick up the handset and press P; you should hear a dial tone.

5Set the dial mode.

If you have touch tone service, the phone is ready to use as soon as the batteries are charged.

If you have dial pulse (rotary) service, you’ll need to change the dial mode. When the phone is off, press P, *, #, Pto set the dial mode to dial pulse. To return to touch tone dialing, press P, *, *, P.

4

Image 6

Contents Revised Part 1 Important Product InformationAdvanced American Telephones. All rights reserved Contents Installation Before You InstallInstall the handset battery Attach the belt clip to the cordless handset optional Set the dial mode Table/Desk InstallationCharge the handset battery Check for dial toneWall Installation Connect the telephone line cord Connect the power cordPosition the wall mount adapter on the base Follow Steps 3-5 in Table/Desk Installation Mount the base on the wallTelephone Operation Page/Handset Locator Temporary Tone Dialing Handset Ringer StyleRinger Off Headset Jack Operating RangeTelephone Memory About Mailboxes Audible IndicatorsAnswering System Operation About AnnouncementsRecord Your Announcement Press Uuntil you hear Set Outgoing MessageAnswering System Feature Setup Feature SummaryDelete Messages Adjust Playback VolumeListen To, Save & Delete Messages Play MessagesCall Screening/Intercept Record a MemoMessage Window Display Connect with the Answering System Voice MenuRemote Access Commands Charging the Handset Battery Pack BatteriesReplacing the Handset Battery Pack Spare Battery Charger Spare battery compartmentIf the phone does not ring when you receive a call Case of DifficultyIf the phone doesn’t work at all, check these items first If you lose a call after changing channels If you hear noise or interference when using the phoneIf you hear other calls while using your phone If messages are incompleteIf you have difficulty hearing messages If CL appears in the Message WindowIf your outgoing announcement isn’t clear