LC2H
How to set
1. Preset value setting mode
This is the mode for setting preset values.
Press the MODE key. Set the digit. | Set the value. |
1)Pressing the MODE key takes you to the preset value setting mode.
Sample display in preset value setting mode
(when preset value is 1000)
2)Pressing the setting key moves the flashing digit left by one. Following the highest digit it returns to the lowest digit and each time the digit setting key is pressed it moves one to the left.
3)Pressing the set key increases the
value by one. (After 9 it returns to 0 and then changes to 1, 2, 3, etc.)
4)Pressing the front panel reset key sets the displayed preset value and returns you to the regular operation mode.
5)In the preset value setting mode if you do not operate the digit setting key or the set key for ten seconds or more you will be returned to regular operation. In this case the preset value will not change.
2. Lock mode
This mode prohibits everything except the preset value setting mode.
+
Press the SET key while pressing |
| Lock | |
| |||
the MODE key. |
|
|
|
1)Pressing the set key while holding down the mode key takes you to the lock mode.
2)The display reads
Display after entering lock mode (Example showing
3) Pressing the setting key changes the
display between “ Lock” and “Un- lock”.
(Example showing “ | Lock”.) |
4)Pressing the front panel reset key sets the content displayed and returns you to regular operation mode.
Note: You will not be returned to regular operation mode if you do not press the front panel reset key.
5) When the lock mode display reads
“Lock”, you will not be able to move to the backlight setting mode, the input setting mode, or the output setting mode.
3. Backlight setting mode
This is the mode for setting the backlight during count up.
+
Press the SET key while pressing |
|
|
| Lit red |
|
|
| Flashes green |
the MODE key. |
|
|
| Lit green |
|
|
| Flashes red |
1)Pressing the SET key two times while holding down the MODE key takes you to the backlight setting mode.
2)The display in the backlight setting
mode reads “ | LEd” |
Display after entering
the backlight setting mode.
3)The LED backlight will be red (initial setting).
4)The backlight changes from flashing green to flashing red to lit green and to lit red with each press of the setting key.
5)Pressing the front panel reset key sets the current backlight color and returns you to regular operation mode.
Note: You will not be returned to regular operation mode if you do not press the front panel reset key.
4. Input setting mode
This is the mode for setting addition or subtraction.
+
Press the SET key while pressing | Addition |
| Subtraction |
| |||
the MODE key. |
|
|
|
1)Pressing the SET key three times while holding down the MODE key takes you to the input setting mode.
2)The display after entering the input
setting mode reads “ | UP” (initial |
setting). |
|
Display after entering input setting mode
(Example showing “UP”)
3)Pressing the setting key changes the display to “dn” (subtraction) and pressing it again changes it to “UP” (addition). The display alternates between “dn” and “UP”.
(Example showing “dn”)
4)Pressing the front panel reset key sets the content displayed and returns you to regular operation mode.
Note: You will not be returned to regular operation mode if you do not press the front panel reset key.
109
CTi Automation - Phone: 800.894.0412 - Fax: 208.368.0415 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
