Panasonic LC2H Compliance with the CE marking, Output setting mode This sets the operation mode

LC2H

5.Output setting mode This sets the operation mode.

+

Press the SET key while pressing	HOLD-A	HOLD-B
the MODE key.	SHOT-B	SHOT-A

1) Pressing the SET key four times while

holding down the MODE key takes you to

2) Lock mode

+

Press the SET key while pressing	Un-Lock	Lock
the MODE key.

When the lock is set, you cannot enter modes other than backlight setting mode.

the output setting mode.

2) The display reads “HoLd-A” (initial

setting) after entering the output setting

mode.

3) Pressing the setting key causes the

display to change as follows:

HOLD-B (Output maintain/over count I)

SHOT-A (One shot/over count)

3) Backlight setting mode

+

Press the SET key while pressing

the MODE key.

4) Input setting mode

+

Press the SET key while pressing

the MODE key.

5) Output setting mode

+

Press the SET key while pressing

the MODE key.

Lit red	Flashes green
Lit green	Flashes red

Addition Subtraction

HOLD-A HOLD-B

SHOT-B SHOT-A

Front panel reset key

Regular operation mode

Mode changes as follows by pressing the SET key while holding down the MODE key.

Lock mode	Backlight setting mode
Output setting mode	Input setting mode

SHOT-B (One shot/recount I)

HOLD-A (Output maintain/hold count)

4)Pressing the front panel reset key sets the display content and returns you to regular operation mode.

Note: You will not be returned to regular operation mode if you do not press the front panel reset key.

Please be aware that after doing a front panel reset key and returning to regular operation mode, the preset values, count value and output will be as shown in this table.

	Preset	Count value	Output
	value		change
Lock	⋅	⋅	⋅
mode
Backlight	⋅	⋅	⋅
setting
mode
Input	⋅	Addition: “0”
setting		Subtraction:	ON➝OFF
mode		“Preset value”
Output	⋅	Addition: “0”
setting		Subtraction:	ON➝OFF
mode		“Preset value”

Note: “⋅” sign: No change

Changing the preset value

1.It is possible to change the preset value even during counting. However, be aware of the following points.

1) If the preset value is changed to less than the count value with counting set to the addition direction, counting will continue until it reaches full scale, returns to zero, and then reaches the new preset value. If the preset value is changed to a value above the count value, counting will continue until the count value reaches the new preset value.

2)Suppose that the counter is preset to count down. Whether a preset count down value is smaller or larger than the count value, the counter counts down to “0 (zero)”.

2. If the preset value is changed to “0”, the counter will not complete count- up. It starts counting up when the counting value comes to “0 (zero)” again.

1)Addition (up-count) input when counting is set to the addition direction, counting will continue until full scale is reached, return to zero, and then complete count-up.

2)Subtraction (down-count) input when counting is set to the subtraction direction, counting will continue until full scale “–9999999” is reached, and then the

display will change to “ ”.

Compliance with the CE marking

• EMC Directive (89/336/EEC)

The LC2H Preset Counter conforms to the EMC Directive as a simple counter. Applicable standards: EN61000-6-4, EN61000-6-2

110

CTi Automation - Phone: 800.894.0412 - Fax: 208.368.0415 - Web: www.ctiautomation.net - Email: info@ctiautomation.net