LC2H
For LC2H total counter (installation frame type)
(1)Remove the battery cover from the case.
(2)Remove the battery from the side of the case. The battery will come loose if you put the battery side face down and lightly shake the unit.
(3)Before inserting wipe clean the surface of the new battery.
(4)Insert the new battery with the “+” and
(5)After replacing the battery, return the battery cover to the case. Verify that the hook of the battery cover is properly engaged.
(6)Before using press the reset button on the front.
1
2
“+” side
5
“−” side
6. Terminal connection
Tighten the terminal screws with a torque of 0.8 N·cm or less.
6
Options
1.Accessories (for LC2H total counter)
Panel cover (black)
COUNTER
RESET
LC2H
Part No.: AEL3801
You can change the design of the front panel by replacing it with this black panel cover. The counter comes with an ash gray panel cover as standard.
Note: No panel cover accessory (black) is available for the LC2H preset counter.
114
2. Lithium battery (3 V)
P anasonic CR2477 JA 3V PAN
Part No.: ATH3802
Packaged with the LC2H (excluding the PC board mounting type).
Warning
•Make sure the “+” and “−” polarities are positioned correctly.
•Do not throw the old battery into a fire, short circuit it, take it apart, or allow it to come into contact with heat.
•The battery is not rechargeable.
3.Installation parts Mounting frame
(Suitable for installation frame type LC2H total counter and LC2H preset counter)
Part No.: ATH3803
Packaged with the mounting bracket type LC2H total counter
Rubber gasket
(Suitable for installation bracket type LC2H total counter and LC2H preset counter)
Part No.: ATH3804
Packaged with the mounting bracket type LC2H total counter
CTi Automation - Phone: 800.894.0412 - Fax: 208.368.0415 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
