AT&T 9002 user manual Headset Jack

Page 15

OPERATION

Headset Jack

You can use this telephone hands-free when you install an optional headset and use the belt clip provided.

1Attach the belt clip (see “Belt Clip” in the INSTALLATION section of this manual).

2Plug the headset (purchased separately) into the jack located on the right side of the handset. (For best results, use only an accessory headset with 2.5 mm plug.) Do not force the connection, but make sure the plug fits securely.

3Follow instructions under “Making a Call” or “Answering a Call.”

NOTE: The earpiece and microphone on the handset are disabled when the headset is plugged in.

13

9002_book.1AT&T

13

8/12/98, 4:09 PM

Image 15

Contents Part Philips Consumer Communications L.P. All rights reserved Contents 9002book.1AT&T 12/98, 409 PM Installation Table/Desk InstallationSet the dial mode Check for dial tone Connect the power cordConnect the telephone line cords to the base Charge the handset batteries for 16 hoursConnect the line cords Wall InstallationFollow Steps 7 and 8 under Table/Desk Installation Belt ClipMount the telephone on the wall jack Operation Operation Redial Making a CallAnswering a Call Ending a CallTemporary Tone Handset Ringer VolumeBase Ringer Volume Speakerphone VolumeIntercom Special Telephone ServicesHold MuteSwitching a Conference Call to the Base Conference CallsFour-Way Conference Calls Headset Jack Operating Range Telephone Memory Charging the Handset Battery Pack Replacing the Handset Battery PackBatteries Batteries If you hear noise or interference when using the phone Case of DifficultyIf the phone doesn’t work at all, check these items first If you hear other calls while using your phone If the phone does not ring when you receive a call