AT&T 9002 user manual Belt Clip, Mount the telephone on the wall jack

Page 8

INSTALLATION

the excess line cord under the tab on the bottom of the telephone base. Plug the line cord into your other one-line wall jack. You will be connected to Line 2.

5Mount the telephone on the wall jack.

Position the telephone base so the mounting studs on the wall jack fit into the base of the telephone. Slide the telephone down on the mounting studs until the phone locks into place.

6Follow Steps 7 and 8 under Table/Desk Installation.

CAUTION: Use only the AC power adapter supplied with this

telephone. Class 2 Power Source. Input: AC 117V, 60 Hz, 9W Output: DC 9V, 500mA

Belt Clip

If you wish, you can attach the belt clip to the cordless handset, following the illustrations below.

To Attach

To Remove

6

9002_book.1AT&T

6

8/12/98, 4:09 PM

Image 8

Contents Part Philips Consumer Communications L.P. All rights reserved Contents 9002book.1AT&T 12/98, 409 PM Set the dial mode InstallationTable/Desk Installation Connect the power cord Connect the telephone line cords to the baseCharge the handset batteries for 16 hours Check for dial toneWall Installation Connect the line cordsMount the telephone on the wall jack Follow Steps 7 and 8 under Table/Desk InstallationBelt Clip Operation Operation Making a Call Answering a CallEnding a Call RedialHandset Ringer Volume Base Ringer VolumeSpeakerphone Volume Temporary ToneSpecial Telephone Services HoldMute IntercomFour-Way Conference Calls Switching a Conference Call to the BaseConference Calls Headset Jack Operating Range Telephone Memory Batteries Charging the Handset Battery PackReplacing the Handset Battery Pack Batteries If the phone doesn’t work at all, check these items first If you hear noise or interference when using the phoneCase of Difficulty If the phone does not ring when you receive a call If you hear other calls while using your phone