StandardModular
Electrical Telephone Jacks
Outlet
Telephone Jacks
INSTALLATION
L1 | L2 | L1/L2 |
|
| OR |
Power cord
Telephone line cords
Table/Desk Installation
1Choose a spot near an electrical outlet and a telephone jack. This phone requires a modular telephone jack and a standard electrical outlet (110vAC). This outlet should not be controlled by a wall switch.
2Install the handset battery.
(For an illustration of battery installation, see BATTERIES in this manual.)
•Remove the battery cover by pressing on the indentation and sliding downward.
•Install the battery pack so that the metal contacts on the bottom of the battery are aligned with the charging contacts in the battery compartment.
•Replace the battery cover by sliding it on its track up over the battery compartment until it snaps firmly in place.
3Set the dial mode.
If you have touch tone service, set the switch on the side of the base to TONE. If you have dial pulse (rotary) service, set the switch to PULSE. Even if you have dial pulse service, you can still use telephone services requiring tone signals. See “Temporary Tone” in the OPERATION section of this manual.
3
9002_book.1AT&T | 3 | 8/12/98, 4:09 PM |