AT&T 9002 user manual Operation

Page 9

OPERATION

Send a paging tone to handset/ intercom between base and handset

Mute the microphone

Put a caller on hold

Initiate a conference call

Adjust speaker volume

PULSE/TONE switch and Line 1 and Line 2 RINGER switches on side of base

Line 2 – Activate speakerphone

End a call

Line 1 and Line 2 lights flash when handset or extension is in use

Line 1 – Activate speakerphone

Light goes on when handset is charging in the base

Light goes on when base is connected to power

Directory Card

7

9002_book.1AT&T

7

8/12/98, 4:09 PM

Image 9

Contents Part Philips Consumer Communications L.P. All rights reserved Contents 9002book.1AT&T 12/98, 409 PM Installation Table/Desk InstallationSet the dial mode Connect the telephone line cords to the base Connect the power cordCharge the handset batteries for 16 hours Check for dial toneConnect the line cords Wall InstallationFollow Steps 7 and 8 under Table/Desk Installation Belt ClipMount the telephone on the wall jack Operation Operation Answering a Call Making a CallEnding a Call RedialBase Ringer Volume Handset Ringer VolumeSpeakerphone Volume Temporary ToneHold Special Telephone ServicesMute IntercomSwitching a Conference Call to the Base Conference CallsFour-Way Conference Calls Headset Jack Operating Range Telephone Memory Charging the Handset Battery Pack Replacing the Handset Battery PackBatteries Batteries If you hear noise or interference when using the phone Case of DifficultyIf the phone doesn’t work at all, check these items first If you hear other calls while using your phone If the phone does not ring when you receive a call