AT&T 9002 user manual Contents

Page 3

INSTALLATION	3
Table/Desk Installation	3
Wall Installation	5
Belt Clip	6
OPERATION	7
Making a Call	9
Answering a Call	9
Ending a Call	9
Redial	9
Handset Ringer Selection and
Ringer OFF	9
Handset Ringer Volume	10
Base Ringer Volume	10
Speakerphone Volume	10
Temporary Tone	10
Special Telephone Services	11
Hold	11
Mute	11
Page	11
Intercom	11
Conference Calls	12
Switching a Conference Call
to the Base	12
Four-Way Conference Calls	12
Headset Jack	13

CONTENTS
OPERATING RANGE	14
TELEPHONE MEMORY	15
Storing Memory Numbers	15
Replacing Stored Memory Numbers ...	15
Storing a Pause in a Memory Number . 15
Dialing Memory Numbers	15
Memory Guard	15
BATTERIES	16
Charging the Handset Battery Pack	16
Replacing the Handset Battery Pack ...	16
IN CASE OF DIFFICULTY	18

1

9002_book.1AT&T

1

8/12/98, 4:09 PM

Image 3

Contents Part Philips Consumer Communications L.P. All rights reserved Contents 9002book.1AT&T 12/98, 409 PM Installation Table/Desk InstallationSet the dial mode Check for dial tone Connect the power cordConnect the telephone line cords to the base Charge the handset batteries for 16 hoursConnect the line cords Wall InstallationFollow Steps 7 and 8 under Table/Desk Installation Belt ClipMount the telephone on the wall jack Operation Operation Redial Making a CallAnswering a Call Ending a CallTemporary Tone Handset Ringer VolumeBase Ringer Volume Speakerphone VolumeIntercom Special Telephone ServicesHold MuteSwitching a Conference Call to the Base Conference CallsFour-Way Conference Calls Headset Jack Operating Range Telephone Memory Charging the Handset Battery Pack Replacing the Handset Battery PackBatteries Batteries If you hear noise or interference when using the phone Case of DifficultyIf the phone doesn’t work at all, check these items first If you hear other calls while using your phone If the phone does not ring when you receive a call