AT&T E2811 user manual Message counter displays

Answering system operation

		Message counter displays
		The message counter usually displays the total
		number of memos and incoming messages. See the
		list below for explanations of other displays in this
		counter.
Message counter		Message counter displays
	0		No messages.
		0 (flashing)	The clock needs to be set (page 31).
	1-99		Total number of messages and memos, or
			message number currently playing.
		1-99(flashing)	Total number of messages and memos.
			The number flashes when there are new
			(un-reviewed) messages.
			If the telephone loses power, after power
			is restored, the number in the message
			counter will flash to indicate the clock
			needs to be set.
	10-99		Current remote access code while setting
			(page 33).
		1-99(counting)	Elapsed time while recording a memo
			(page 35) or announcement up to 90 sec-
			onds (page 32).
		99 (flashing)	Memo recording time has exceeded the
			maximum counter capacity of 99 seconds.
		F (flashing)	Memory is full. Messages must be deleted
			before new messages can be received.
	--		System is answering a call, being
			accessed remotely, or the clock is being
			set.
		--(flashing)	System is being setup or initialized.
		02, 04, 06, tS	Current number of rings while setting
			(page 33).
	1-8		Displayed for two seconds while telephone
			base speaker volume being adjusted.
		HI, LO, OF	Displayed for two seconds while telephone
			base ringer volume being adjusted.

36