AT&T EL42308, EL42208, EL42258 user manual Changing feature options, Setup

ANNC. RECORD

NOTES:

1.The message alert tone will beep only if all the conditions below are met: Answering system is on; Message alert tone

setting is on;

There are new messages.

2.Press any base key to temporarily silence the message alert tone. If you press DELETE twice while the phone is not in use, you will delete all old messages and the message alert tone will be temporarily silenced. The message alert tone will be re-activated with the next incoming message.

Answering system

Changing feature options

You can set and change the answering system features described below:

1.Press SETUP repeatedly until you hear the feature you want to modify.

2.Press SKIP or REPEAT to change the setting.

3.Press SETUP to set your selection and move to the next menu option.

4.Press PLAY/STOP to confirm the setting and exit the menu.

Feature options (Default settings underlined)

System announces:	Feature description:
"Number of rings,"	Choose number of rings before
current setting, then	the system answers a call. When
"To change the setting	toll saver is active, the system
press SKIP or REPEAT;	answers after two rings if you
to continue setup, press	have new messages, and after
SETUP."	four rings if you have no new
Options: 2/4/6/toll saver	messages. If you are making a
	long distance call to retrieve
	messages, you may disconnect
	your call after three rings so that
	there will be no long distance
	charge incurred.
“Base ringer,” current	Choose the base ringer volume
setting, then “To change	between high and low level, or
the setting, press SKIP	turn the base ringer off.
or REPEAT; to continue
setup, press SETUP.”
Options: high/low/off

"Remote access code," current setting, then "To change the setting press SKIP or REPEAT; to continue setup, press SETUP."

Options: (select a two- digit code) 19

Select a two-digit number (10-99) for remote access from another telephone (page 41).

NOTE: Press and hold

SKIP or REPEAT to

increase or decrease the remote access code number by 10.

"Message alert tone," current setting, then "To change the setting, press SKIP or REPEAT; to continue setup, press SETUP."

Options: on/off

When on, the telephone beeps every 10 seconds when there are new messages.

36