Programming the Interference Eliminator Code
The interference eliminator code helps minimize interference by providing code combinations that filter out static, noise, and unwanted messages.
1. In programming mode, press Suntil y displays and the code number flashes.
2. Press [ or ] to select the code (see page 42).
3. Press and hold Push to Talk to exit programming mode, or press S to continue programming.
Programming the Available Channels (CLS1410 only)
If you need fewer channels, you can reduce the number of available channels.
1. In programming mode, press Suntil = displays and the channel number flashes.
2. Press [ or ] to select the number of channels you want available.
3.Press and hold Push to Talk to exit programming mode, or press S to continue programming.
Note: The radio retains settings for channels made unavailable.
Programming Mode
29
Programming Mode
Programming Call Tones and VibraCall® (CLS1410 only)
Your radio can transmit call tones to other radios in your group so you can alert them that you are about to talk. Your radio is programmed at the factory with call tones turned off (set to 0), but you can change this setting to choose a distinctive call tone.
The VibraCall® feature is an additional call tone option that makes the CLS1410 radio vibrate briefly when it receives if you have not transmitted or received in the last
30 seconds. Select call tone 4 to turn VibraCall® on. i displays on the radio when VibraCall® is on.
1. In programming mode, press Suntil E displays.
2. Press [ or ] to hear and select the call tone. Select call tone 4 for VibraCall® (CLS1410 only).
3. Press and hold Push to Talk to exit programming mode, or press Sto continue programming.
To transmit your call tone, press B on the side of the radio.
30