Motorola CLS1110 CLS1410 manual Cloning Radio Settings, Programming Microphone Gain

Paired pockets

LEDs

Suntil h displays and the channel

Programming Microphone Gain

You can adjust the microphone sensitivity to suit different users or operating environments.

1. In programming mode, press Suntil g and ? display.

2. Press [ or ] to select the sensitivity level: 3 = High sensitivity, for quiet environments 2 = Medium sensitivity (default)

1 = Low sensitivity, for loud environments

3.Press and hold Push to Talk to exit programming mode, or press Sto continue programming.

Editing the Scan List (CLS1410 Only)

For faster scanning and to avoid hearing unwanted transmissions, you can edit the scan list to skip channels.

1. In programming mode, press

number and Y or n flash. 2. Press [ or ] to select the channel you want to remove from the

scan list.

3.Press Tto display either Y to include the channel or n to exclude the channel.

4.Press and hold Push to Talk to exit programming mode, or press Sto continue programming.

Programming Mode

31

Cloning Radio Settings

32

Cloning Radio Settings

You can copy _ Series radio settings from one radio (the source) to a second radio using the 56531 Multi-Unit Charger (MUC) optional accessory. See the MUC User's Guide for more information.

You can clone only one radio at a time. A multi-channel radio can clone to a single- channel radio, but only the first channel is cloned. The MUC does not have to be

plugged in for cloning, but both radios require charged batteries.

1. On the source radio, press and hold Push to Talk and Tfor 3 seconds while turning the radio on. The radio beeps and displays k.

2. Place the source radio in one of the charging pockets. 3. Turn the target radio on and place it in the charging pocket that is paired with the pocket containing the source radio. There are 3 paired charging pockets as indicated by the

3 pairs of charging status LEDs.

4. Press and hold T on the source radio. The source radio

transmits its settings to the target radio. If cloning was successful, P or Pass or “F” for Fail displays on the source

radio and the target radio displays all feature icons. If cloning was not successful, F or Fail displays on the source radio.

5.Turn the target radio off and back on again to use.

6.To clone another radio, repeat steps 3 and 4.

7.To exit programming mode on the source radio, press and hold Push to Talk until k no longer appears.