Motorola CM300TM Delete a Nuisance Channel, Edit a Scan List, Restore Channels to the Scan List

DELETE A NUISANCE CHANNEL

Note: Your dealer/programmer must prepro- gram a button to Nuisance Delete to access this feature.

If a channel continually generates unwanted calls or noise (a “nuisance” channel), you can temporarily remove it from the scan list:

1While the radio is on the Nuisance Channel, press the preprogrammed Nuisance Channel Delete button until you hear a tone.

2Release the Nuisance Channel Delete button. The nuisance channel is deleted.

–or–

2Press the preprogrammed Scan button to stop the scan.

3Press the preprogrammed Scan button again to start scanning again. The Deleted Nuisance Channels are restored to the scan list.

–or –

4Gor Hto select a channel that has not been preprogrammed by your dealer/ programmer to stop Scan. Once you return to the original channel, the deleted nuisance channels are restored to the scan list.

SCAN

Note: You cannot temporarily delete the channel that has been preprogrammed by your dealer/programmer as your designated scan channel, a priority channel, or the last remaining channel in the scan list.

Restore Channels to the Scan List

1Power off the radio. Once the radio is powered on again, the deleted nuisance channels are restored to the scan list.

EDIT A SCAN LIST

Your radio can support up to 16 Scan lists. Each Scan list can contain up to 16 channels. The same channel can be included in several Scan lists, and the same Scan list can be assigned to several channels. Scan lists are assigned per channel, by your dealer/ programmer. When you edit a Scan list, you can either add, delete, or prioritize channels.

29

English