BlueAnt
Basic Headset Functions
For easy reference, also see the Button/Function Matrix and the Quick Start Guide.
1.Power ON: Press and Hold the MFB 
for 3 seconds. The solid Blue LED will light up, and if the battery has ample charge the Blue LED will stay on for up to 5 Seconds. If the battery is low a solid Red LED will be displayed. After powering ON, your headset will automatically connect to your last used phone if it is in operating range. If this phone is not range, the Z9i will enter idle mode after 60 seconds. If no phone has yet been Paired, the Z9i will enter into Pairing mode.
2.Power OFF: Press and Hold the MFB 
for 3 seconds. The Red LED flashes three times.
3.Enter Pairing Mode: With the Z9i OFF, Press and Hold the MFB 
for about 6 seconds until the LED flashes Blue. The Z9i will stay in pairing mode for 2 minutes then will go into idle mode. To
4.Make a Call: Dial the number using your phone as normal. Audio will automatically transfer to the headset.
5.To Answer or End a call: Click the MFB 
once when there is an incoming call. Click the MFB 
to end the call.
6.Reject* a call: Press and Hold the MFB 
for 1 second when there is an incoming call.
7.Redial*: the last call, Press and Hold the Volume 
Button for about 3 seconds. To cancel Redial, click the MFB 
8.Activate Voice Dialing*: While connected to a phone, Press the MFB 
once. Voice commands must have been previously recorded into your phone (see your phones user guide for specific instructions).
9.Volume level: Click Volume 
or Volume 
during a call to adjust the desired level. Volume changes will be remembered for the next call. Be sure to use the headset at a comfortable and safe volume level.
10