English
Common Operations
Setting the dimmer control
You can set the dimmer control “ON” or “OFF”.
∗The factory default setting is “ON”.
3 - 1 . Select “DIMMER”.
3 - 2 . Touch [
] key to enter detail setting stage.
3 - 3 . Slide along [ 
] slider or touch [ ]/[ ] key to select “ON” or “OFF”.
Anti-theft indicator
The red
∗The factory default setting is “OFF”.
3 - 1 . Select “BLINKING LED”.
3 - 2 . Touch [ ] key to enter detail setting stage.
3 - 3 . Slide along [ | ] slider or touch [ ]/[ ] |
key to select | “ON” or “OFF”. |
Setting the external amplifier
When an external amplifier is used, the noise can be decreased by turning off the power supply of the internal amplifier.
∗The factory default setting is “OFF”.
3 - 1 . Select “AMP CANCEL”.
3 - 2 . Touch [
] key to enter detail setting stage.
3 - 3 . Slide along [ | ] slider or touch [ ]/[ ] |
key to select | “ON” or “OFF”. |
ON
Use with connected AMP.
OFF
Use for inside AMP.
Accessory interrupt setting
If you connect this unit and supported accessory with a separately sold cable, you can listen the output sound on your car speakers.
∗The factory default setting is “OFF”.
3 - 1 . Select
3 - 2 . Touch [
] key to enter detail setting stage.
3 - 3 . Slide along [ | ] slider or touch [ ]/[ ] |
key to select | “ON”, “OFF” or “MUTE”. |
ON
You can listen from the speakers when accessory is connected to this unit.
∗When listening to the connected accessory, you can adjust the volume by turning the [ROTARY] knob.
OFF
This unit continues normal operation even when the accessory is interrupted.
MUTE
The sound from this unit is muted during accessory is interrupted.
Performing a system check
This function allows you to perform a system check from the adjust mode when required.
3 - 1 . Select “SYSTEM CHECK”.
3 - 2 . Touch [ENT] key. “SYSTEM CHECK” ap- pears in the display.
3 - 3 . After finish checking, this unit will switch to previous mode.
AUX function
This system has an external input jack on the rear panel so you can listen to sounds and music from external devices connected to this unit.
Selecting AUX IN sensitivity
Make the following settings to select the sensi- tivity when sounds from external devices con- nected to this unit are difficult to hear even after adjusting the volume.
∗The factory default setting is “MID”.
1.During AUX mode, touch the [
] key to switch to ADJ menu.
2.Select OPTION in the menu to enter AUX OP- TION mode.
3. | Select “AUX SENSE” and touch [ | ] key to | |
| enter detail setting stage. |
| |
4. | Slide along [ | ] slider or touch [ | ]/[ ] key |
| to select “HIGH”, “MID” or “LOW”. |
| |
Note:
When AUX mode is selected, AUX IN sensitivity can be set.
38 FZ709E