Clarion FZ709E owner manual Common Operations Adjustment Mode, Setting the display brightness

English	Common Operations
	Adjustment Mode
	1.	Touch the [ ] key to switch to ADJ menu.
	2.	Select “SETTING” in the menu to enter setting
		mode.
	3.	Each time you slide along the [				] or touch
		[ ]/[ ] key, the setting mode changed as
		following order:
		“DISP BRIGHT”	“BEEP”			“CODE”
		“SCREEN SAVER”		“AUTO SCROLL”
		“SCROLL SPEED”			“DIMMER”
		“BLINKING LED”	“AMP CANCEL”
		“INT- SWITCH”	“SYSTEM CHECK”

∗If no operation is performed for more than 10 seconds, ADJ mode is cancelled and the display returns to the previous mode.

Setting the display brightness

You can adjust the display brightness to match the angle of installation of the unit.

∗The factory default setting is “5”. (Adjustment level: 1 to 8)

3	- 1	. Select “DISP BRIGHT”.
3	- 2	. Touch [ ] key to enter detail setting stage.
3	- 3	. Slide along [	] slider or touch [ ]/[ ]
		key to adjust the value.

Notes:

If both the dimmer and the car’s illumination are turned on, “ILLUMI ON” and the adjustment value will be displayed. If the dimmer is turned on and the car’s illumination is turned off, “ILLUMI OFF” and the adjustment value will be displayed.

If the dimmer is turned off, only the adjustment value will be displayed.

The display brightness level setting during dimmer and car’s illumination are turned on has indepen- dent adjustment value.

Setting the beep

∗	The factory default setting is “ON”.
3	- 1	. Select “BEEP”.
3	- 2	. Touch [ ] key to enter detail setting stage.
3	- 3	. Slide along [	] slider or touch [ ]/[ ]
		key to select “ON” or “OFF”.

Setting the code 3 - 1 . Select “CODE”.

3 - 2 . Touch [ ] key to enter detail setting stage.

When no code is registered
3	- 3	. Slide along [	] slider or touch [ ]/[ ]
		key to adjust the value.
3	- 4	. Touch [ ] / [	] key to set the previous or
		next digit.

3 - 5 . During finish adjustment, touch [ENT] key for 2 seconds to memory the new setting value.

36 FZ709E