GE 2-9892 manual Reverse the Handset Hook, Remove the Base Plate, Installation for Wall Mount Use

Page 12

INSTALLATION – WALL MOUNT (optional)

1.Reverse the Handset Hook

Firmly slide the HANDSET HOOK out of the CRADLE. Rotate it 180° and slide it back into the CRADLE.

2.Remove the Base Plate

For wall mount installations, press in the two tabs and pull the BASE PLATE from the back of the telephone.

Note: For future reference, please copy your three digit security code located on the bottom of the unit.

3.Connect the Power Cord

Insert the right angle plug of the POWER CORD into the POWER JACK on the back of the telephone. Let the POWER CORD run down the center of the telephone back.

Note: Do not plug POWER SUPPLY into wall outlet until all other steps are completed.

4.Connect the Short Telephone Line Cord Plug either end of the SHORT TELEPHONE LINE CORD into the PHONE LINE JACK on the back of the telephone.

5.Install the Base Plate so that the Arrows Face Upward

Position the POWER CORD and the SHORT TELEPHONE LINE CORD to run through the top notch in the BASE PLATE. Feed the SHORT TELEPHONE LINE CORD through the large opening in the back of the BASE PLATE. Snap the BASE PLATE into the lower set of tab openings in the base of the telephone, making sure the POWER CORD runs through the bottom notch in the BASE PLATE.

•C. Installation for Wall

•Mount Use

•
•	ANSWERPHONE
•	VOICE TIME/DAY STAMP
•
•
•	MEMO MESSAGE RESET PLAY•STOP	ANSWER ON/OFF
•
•
•
•
•
•
•
•
•

•PRESS

•IN TABS

•
•
•
•	POWER VDC
•	E LINE
•
•
•
•
•
•
•
•	THIS END UP
•	FOR WALL MOUNT
•
•
•
•
•
•
•
•

12

Image 12

Contents Answer-PhoneTMwith Voice Time/Day Stamp Table of Contents Introduction Parts Check ListFull Feature Telephone Number Memory Hearing Aid Compatible Telephone FeaturesCall Screening Speaker Power Failure ProtectionTM Music during tape shuttleOne-Touch operation for ease of use Line Memory Store/In Button Stores phone numbers in phone memory Handset Coiled CordTelephone Controls Door Opens for access to controls of the answering system Message Reset Button Resets and clears all messagesSpeaker Answerer ControlsSecurity Code, on bottom of unit, not shown Installation Desk or Table TOP Connect the Coiled CordConnect the Long Telephone Line Cord Plug in the Power Supply Install the Base Plate so that the Arrows Face Upward Installation for Wall Mount UseReverse the Handset Hook Remove the Base PlateInstallation Wall Mount AnswerphonePULSE/TONE Switch Ringer VolumeTelephone Operation To Make a CallHow to Use AutomaticWait for dial tone Press Redial Button Refer to the telephone company’s instruction on useTelephone Memory Operation Frequently Called Numbers in Memory For Example Memory LocationTo initiate Chain Dialing Adjust Volume control to a comfortable level Introduction Setting Time/Day StampAnswering System Operation To set hourAnswer LED as a ready indicator Answer LED as an IN-USE IndicatorTo set day Checking the Time/Day StampTo Play Incoming Messages To Stop PlaybackTo Repeat Playback You find a comfortable volume level Message ResetTape Press and hold down Memo button. Start recording afterRemote Operation To Play Messages from a remote locationTo Replay Messages To Reset Incoming Message Tape To ResetTo Leave a Remote Memo To Record a New Outgoing AnnouncementRoom MonitorIf Tape is full, unit will beep after tenth ring Remote onCase of Difficulty Answerer Problem Solution Battery CARTRIDGE, pop it up, lift Battery out Following manner Accessory Order Form 9892 ONE Year Limited Warranty What will we do?FCC Registration Information Interference InformationHearing AID Compatibility S W E R P H O N E TM