GE 2-9892 manual You find a comfortable volume level, Tape, Message Reset, Recording Memo

ANSWERING SYSTEM OPERATION

You can use the volume control on the side of the Answer-PhoneTM		•
to adjust the volume of the system’s speaker. Slide the switch until		•
you find a comfortable volume level.		•
		•
		•
		•
		•
To screen calls, set the system to answer calls, and adjust the		•
		•
VOLUME setting so you can hear the OGA and the caller’s		•
message on the Answer-PhoneTM’s built-in speaker.
		•
If you decide to take the call, lift the handset of the Answer-
		•
PhoneTM or any extension on the line. The system will
		•
automatically stop recording and you may speak to the caller.
		•
If you wish to get rid of your old messages and want to set the		•
tape to have new messages record over the old messages:		•
Press the MESSAGE RESET button.		•
•	MESSAGE LED will clear	•
		•
•	New incoming messages will record over old messages on
		•
	the tape.
		•
Press and hold down MEMO button. Start recording after the		•
tone. Speak into the microphone and release the MEMO button		•
when finished. The unit will record the time and day stamp and		•
the MESSAGES indicator will be advanced by one count.		•
		•
		•
When the system’s tape is full, the MESSAGES indicator will		•
		•
flash rapidly. The unit will answer on the tenth ring, and beep
		•
once. If the caller does not enter the unit’s (factory set three digit)
security code within ten seconds, the Answer-PhoneTMwill hang		•

up. To make room for new messages, press PLAY/STOP to listen •

to your messages, press MESSAGE RESET to erase them.	•
	•
	•
	•
	•
	•

G. Message

Volume

Control

VOLUME	HI
LO

H. Screening Your Calls

VOLUME	HI
LO

I. Message

Reset

MEMO	MESSAGE RESET PLAY•STOP
FLASH	REDIAL
	MESSAGES
	MEMORY

J.Recording

a Memo

MEMO	MESSAGE RESET PLAY•STOP
FLASH	REDIAL
	MESSAGES
	MEMORY

K. When Tape is Full

MEMO	MESSAGE RESET PLAY•STOP
FLASH	REDIAL
	MESSAGES

21