GE 2-9892 manual Case of Difficulty

Page 25

IN CASE OF DIFFICULTY

If your Answer-PhoneTMdoes not work properly, follow the Service Check List. If it is still inoperative, then disconnect the Answer-PhoneTMand try another telephone to determine if the problem is with the telephone line. If it is the telephone line, notify the telephone company for service.

If the Answer-PhoneTMcontinues to malfunction, please make sure you have followed all the instructions in this manual to correct the problem.

Refer to the service information on p. 31 of this guide if the problem cannot be corrected and the Answer-PhoneTMmust be disconnected.

TELEPHONE PROBLEM		SOLUTION
1.	No Dial tone	•	Check Cords to make sure they are inserted
			correctly.
		•	Does HOOK SWITCH extend fully when
			handset is removed from cradle?
2.	Phone does not dial	•	Check PULSE/TONE switch. Place in the
			PULSE position.

3.	You cannot be heard by other	•	Check that handset coil is fully inserted at
	party		both ends.

4.	Memory Dialing Problems	•	Did you program number correctly?
		•	Did you follow the proper dialing sequence?

5.	Incoming and Outgoing voice	•	Check that other phones are off hook at the
	volume is too low		same time. If so, this is a normal condition as
			volume drops when additional phones are
			used at once.

6.	Phone does not ring	•	Is RINGER SELECT set to OFF position?
		•	Are you using too many phones on one line?
			(The total REN of all phones should not be
			greater than the maximum REN for your
			calling area. Usually 5.)

7.	Tone Feedback Flutter while	•	This is normal as power is fluctuating with
	dialing in pulse mode		phone out-pulsing.

25

Image 25

Contents Answer-PhoneTMwith Voice Time/Day Stamp Table of Contents Parts Check List IntroductionHearing Aid Compatible Telephone Features Full Feature Telephone Number MemoryMusic during tape shuttle Call Screening Speaker Power Failure ProtectionTMOne-Touch operation for ease of use Line Handset Coiled Cord Memory Store/In Button Stores phone numbers in phone memoryTelephone Controls Message Reset Button Resets and clears all messages Door Opens for access to controls of the answering systemSpeaker Answerer ControlsSecurity Code, on bottom of unit, not shown Connect the Coiled Cord Installation Desk or Table TOPConnect the Long Telephone Line Cord Plug in the Power Supply Installation for Wall Mount Use Install the Base Plate so that the Arrows Face UpwardReverse the Handset Hook Remove the Base PlateAnswerphone Installation Wall MountRinger Volume PULSE/TONE SwitchTelephone Operation To Make a CallAutomatic How to UseWait for dial tone Press Redial Button Refer to the telephone company’s instruction on useTelephone Memory Operation For Example Memory Location Frequently Called Numbers in MemoryTo initiate Chain Dialing Introduction Setting Time/Day Stamp Adjust Volume control to a comfortable levelAnswering System Operation To set hourAnswer LED as an IN-USE Indicator Answer LED as a ready indicatorTo set day Checking the Time/Day StampTo Stop Playback To Play Incoming MessagesTo Repeat Playback Message Reset You find a comfortable volume levelTape Press and hold down Memo button. Start recording afterTo Play Messages from a remote location Remote OperationTo Replay Messages To Reset To Reset Incoming Message TapeTo Leave a Remote Memo To Record a New Outgoing AnnouncementMonitor RoomIf Tape is full, unit will beep after tenth ring Remote onCase of Difficulty Answerer Problem Solution Battery CARTRIDGE, pop it up, lift Battery out Following manner Accessory Order Form 9892 What will we do? ONE Year Limited WarrantyInterference Information FCC Registration InformationHearing AID Compatibility S W E R P H O N E TM