AT&T EP5632/EP5632-2 user manual My telephone

Appendix

Bluetooth System Busy appears on the display.

•Make sure that your cellular phone is in idle mode when connected and on the Active Devices list.

•Make sure that your cellular phone or headset is not connected to any other Bluetooth device.

•The EP5632/EP5632-2 can only use one Bluetooth device at a time.

The PIN on the telephone base does not work.

•The default PIN is 0000.

•If you change the PIN on the telephone base, it will appear on the telephone base display in the pairing process.

I cannot hear any audio on my telephone system when on a CELLULAR call.

•Reset the telephone base. Unplug the unit’s electrical power. Wait for approximately 15 seconds, then plug it back in.

•Turn off your cell phone, then turn it on again.

My telephone	•	Make sure the handset battery is installed and charged correctly (see
system does not		page 14). For optimum daily performance, return the cordless handset
work at all.		to the telephone base after use.
	•	Make sure the power adapter is securely plugged into an outlet not
		controlled by a wall switch.
	•	Make sure the telephone line cord is plugged firmly into the telephone
		base and the modular wall jack.
	•	Reset the telephone base. Unplug the unit’s electrical power. Wait for
		approximately 15 seconds, then plug it back in. Allow up to one minute
		for the cordless handset and base to reset.
	• Remove and re-insert the battery pack. If that still does not work, it may
		be necessary to purchase a new battery pack.
There is no dial	•	First, try all the above suggestions.
tone.	•	Move the cordless handset closer to the telephone base. It might be out
		of range.
	•	The telephone line cord might be malfunctioning. Try installing a new
		telephone line cord.
	•	Disconnect the telephone base from the telephone jack and connect a
		different telephone. If there is no dial tone on the telephone either, the
		problem is in your wiring or local service. Contact your local telephone
		company.

94