AT&T Feature Model 5 manual U t t o n

Page 32

Initial Feature Assignments for Nonattendant Voice Terminals with 1520 Configuration in Standard Square Systems

3 4 - B u t t o n

1 0 - B u t t o n

5 - B u t t o n

●Your system assigns your first eight lines automatically to positions above-the dial pad. You must assign the remaining lines to the but- tons to the right of the dial pad. The numbers in the lower right-hand corner of each button show the order in which lines are assigned to buttons. If you don’t use a button for a line, you can program a feature on the button.

31

Image 32

Contents Merlin Table of Contents Introduction About Square Systems DecisionsSquare VS. Pooled Decision Standard Square Configurations Customized Square ConfigurationsTelephone Lines of Automobile Dealership About Pooled Systems Voice terminal Button Access vs. Dial Access to Line Pools Automatic Route Selection Call Management System CMSADMINISTRATOR/ATTENDANT Console Getting StartedTypes of Consoles Line buttons Auto Intercom buttons 10 through Adm Tel button Used when Using the Console Specifying TOUCH-TONE and Rotary SignalingAllowed Lists Call Restrictions976-3067 Restricted Automatic Route Selection ARS ARS Default Tables Automatic Route Selection Worksheet Page Group Group Call DistributionNight Service with Extra Alert Enhanced Night ServiceNight Service with Group Assignment Night Service with Outward Restriction Night Service with Time SetStation Message Detail Recording Smdr System Speed Dial CodesReturn Interval for Transferred Calls ONE-TOUCH Hold with Call AnnouncementVoice Terminal Programmability Auto Intercom Automatic Line SelectionDo not Disturb Call CoverageCall Pickup Last Number Redial Line PickupNotify SEND, Receive Outside Auto DialTOUCH-TONE Enable Voice Announcement DisableSaved Number Redial Simultaneous Voice and Data CallsInitial Feature Assignments U t t o n Button U t t o n U t t on Button U t t o n Page Page Documents 999-502-143IS