Ultratec Miniprint 425 manual Setting pulse/tone dialing, Setting the number of auto-answer rings

Page 28

Setting pulse/tone dialing

The Miniprint 425 is set for tone dialing, which is correct for almost all telephone lines. But you can change to pulse dialing if your line does not accept tone dialing.This setting remains changed until you change it again or reset the Miniprint 425 or you lose power. Follow these steps to set pulse dialing:

1.Press the options key ( Ctrl + 3 ).You will see PRINT (UP/LOW) CASE on the display.

2.Press the Return the display.

key until you see USING ( TONE) DIAL on

3.Press the Spacebar to change the option.

4.Press the Esc key to save the new setting and leave options or press the Return key to save and go to the next option.

Setting the number of auto-answer rings

Follow these steps to change the number of auto-answer rings to any number between 2 and 9:

1.Press the options key ( Ctrl + 3 ).You will see PRINT (UP/LOW) CASE on the display.

2.Press the RING (2).

Return

key until the display says AUTO ANSWER

3.Press the Spacebar to choose a number between 2 and 9.

4.Press the Esc key to save the new setting and leave options or press the Return key to save and go to the next option.

Turning off Turbo Code

Follow these steps to turn off Turbo Code:

1.Press the options key ( Ctrl + 3 ).You will see PRINT (UP/LOW) CASE on the display.

2 6 • O P T I O N S

Image 28

Contents Using Your Miniprint Acknowledgement Ultratec, Inc Science Drive Madison, WIContents Sticky keys Specifications Index Conversation Etiquette Important safety instructions General safetyBattery safety Introduction Dial keyOverview of the Miniprint Special keys1SETUP Plugging in power and the telephone line Setting pulse or tone dialing Connecting a signaler or telephoneCharging the batteries What kind of telephone line?About Auto ID About the printerSetting the print case Setting the print sizeE T U P 2CALLING Making a call in direct connect Signal light and display Dialing tipsAnswering a call in direct connect Acoustic calling and answering Using Turbo Code interrupt About Turbo CodeWait for response Change to other TTYThree-way calling Type NAME, NUM, or CRTransferring a call A L L I N G 3AUTO-ANSWER Turning on auto-answer Setting the number of telephone ringsInterrupting auto-answer Setting the print size Setting the print case4OPTIONS Setting the number of auto-answer rings Setting pulse/tone dialingTurning off Turbo Code Turning off Auto ID Turning off interruptSetting the Baudot code baud rate 5CARE & Repair Replacing the printer paper Checking the batteries About the batteriesExercising the batteries Replacing the batteries Direct connect TroubleshootingPoor reception Power PrinterResetting the Miniprint RepairCalling for help Sending in the Miniprint 425 for repairSticky Keys Specifications PowerFCC information Technician for helpIndustry Canada information Index Auto-answerD E X 4 Conversation Etiquette GA or SK