Polycom IP 450 Use of IP Networks through the Pstn, Use of Voice Compression through the Pstn

Page 111

7

Safety and Compliance (continued)

Polycom SoundPoint IP450 VoIP Telephone PTC 220/08/077

Special Conditions for the User Manual

PTC General Warning

1.The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has accepted that the item complies with minimum conditions for connection to its network. It indicates no endorsement of the product by Telecom, nor does it provide any sort of warranty. Above all, it provides no assurance that any item will work correctly in all respects with another item of Telepermitted equipment of a different make or model, nor does it imply that any product is compatible with all of Telecom's network services.

The Use of IP Networks through the PSTN

2.Internet Protocol (IP) by its nature introduces delay into speech signals as each data packet is formulated and addressed. Telecom Access Standards recommends that suppliers, designers and installers using this technology for calls to or from the PSTN refer to ITU E Model requirements in the design of their networks. The overall aim is to minimise delay, distortion and other transmission impairments, particularly for those calls involving cellular and international networks, which already suffer extensive delay.

The Use of Voice Compression through the PSTN

3.Because of the extensive delay already experienced when calling cellular and international networks, some of which is already caused by their use of voice compression technologies. Telecom Access Standards will only approve G711 voice technology for use on the PSTN. G711 is an 'Instantaneous Speech encoding Technique' whereas G729 and all its variants are considered 'Near Instantaneous' introducing additional delay into the speech signal.

Echo cancellation

4.Echo cancellers are not normally required in the Telecom PSTN because geographic delays are acceptable where CPE return loss is maintained within Telepermit limits. However, those private networks making use of Voice over IP technology are required to provide echo cancellation for all voice calls. The combined effect of audio / VoIP conversion delay and IP routing delay can cause the echo cancellation time of 64 mS to be required.

Modification of this Polycom SoundPoint IP450 VoIP Telephone for the New Zealand network

5.All samples of Polycom SoundPoint IP450 VoIP Telephones connected to the Telecom network shall be equipped with the following software Rev .5891. Equipped with this software batch the IP telephone is known to comply with PTC220 speech signal delay requirements. Failure to equip the telephone with this version of software when connected to a Telecom New Zealand network breaks the conditions of this Telepermit.

Australia

WARNING ALL SOUNDPOINT IP PHONES

With respect to section 5.4.3.11 of the Australian Communications Authority as Telecommunications Technical Standard AS/ACIF S004 2006:

You should be aware that, under certain operating conditions, the handset earpiece may retain small metallic objects. If this occurs, these objects should be removed before using the handset.

7 - 101

Image 111
Contents Polycom SoundPoint IP 450 Phone User Guide Trademark Information About This Guide Who Should Read This Guide?How This Guide is Organized What’s New in This Guide? Conventions Used in This GuideBold Preferences Recommended References Getting Help and SupportCustomer Feedback Contents Viii Using the Advanced Features of Your Phone Troubleshooting Your PhoneCustomizing Your Phone Productivity Suite Testing Phone Hardware Getting Started with Your Phone Description Introducing Phone ComponentsGetting Started with Your Phone What Displays on the Screen? Icon Description Phone IconsIf you want to Then do this Navigating Menus and Entering DataRegistering Your Phone Troubleshooting Phone IssuesUsing the Polycom Web Configuration Utility Using the Basic Features of Your Phone Locking and Unlocking the Phone Logging Into Phones Placing CallsTo place a call using the handset Answering Calls Answering When Not in Another Call Answering When in Another Call Ending Calls Using a Headset Enabling Headset Memory ModeSelect Settings Basic Preferences Headset Headset Memory Redialing Numbers Using Electronic HookswitchMultiple Calls on Hold Placing Calls on HoldHosting Conference Calls Setting Up Conference CallsPolycom SoundPoint IP 450 User Guide Managing Conference Calls Polycom SoundPoint IP 450 User Guide Adding Parties to Conference Calls Ending Conference Calls Transferring CallsJoining Conferences Splitting Conference CallsSee Placing Calls on Performing a Consultative TransferForwarding Calls Using Static Forwarding Using Dynamic Forwarding Multiple Lines and Do Not Disturb Press , then select Features Do Not DisturbEnabling Do Not Disturb Managing Incoming CallsSelect Features Contact Directory Distinguishing CallsRejecting Calls Diverting Calls Press , and then select Features Call Lists Missed Calls Using Call ListsAdding Contacts Using Your Contact DirectoryPolycom SoundPoint IP 450 User Guide Editing Contacts Placing Calls to Contacts Deleting ContactsSearching the Corporate Directory Using Your Corporate DirectorySelect Features Corporate Directory Searching for ContactsPolycom SoundPoint IP 450 User Guide Placing Calls From the Corporate Directory Adding Contacts From the Corporate DirectoryManaging Speed Dials To assign a new speed dial key Using Voice Mail Using Multiple and Shared LinesSupporting Multiple Lines Supporting Multiple Call Appearances Supporting Multiple Line Keys Per LinePolycom SoundPoint IP 450 User Guide Supporting Shared Lines Locking and Unlocking the PhoneLocking and Unlocking Your Phone About Your User PasswordPress the Lock soft key. Your phone is locked Press , then select Settings Basic Lock PhoneCalling and Answering from a Locked Phone Logging In and Out of a Phone Logging Into PhonesTo log out of a phone Placing Calls from Phones that are in the Logged Out State Changing Your User PasswordPolycom SoundPoint IP 450 User Guide Using Text Messaging Using the Advanced Features of Your PhoneSelect Features Messages Instant Messages Using Buddy Lists Updating Your Presence SettingsSelect Features Presence My Status Managing Buddies Integrating With Microsoft Live Communications Server Select Features Presence Buddy Status Select Features Presence Buddy Status Privacy ListIntegrating With Microsoft Lync Server Adding Buddies Push-to-Talk Mode Broadcasting Messages Using Push-to-Talk and Group PagingPress the Talk soft key to select a channel to broadcast on Sending PTT BroadcastsPolycom SoundPoint IP 450 User Guide Receiving PTT Broadcasts When You’re Not in an Active Call Receiving PTT BroadcastsReceiving PTT Broadcasts During Active Calls Ending PTT Broadcasts Updating Channel Subscriptions Sending Pages Group Paging ModeReceiving Pages Receiving Pages During Active Calls Receiving Pages When You’re Not in an Active CallChanging Where Pages are Played Accessing Features with Your Login Credentials Restarting Your Phone Updating Your Phone’s ConfigurationSelect Settings Basic Restart Phone Changing the Time and Date Display Customizing Your PhoneChanging the Backlight Brightness Changing the BacklightTo modify the backlight intensity Changing the Backlight Timeout Select Backlight Idle IntensitySelect Maximum Intensity Select Settings Basic Backlight Timeout Select Settings Basic Ring TypeChanging the Ring Type Changing the Language Select Settings Basic Preferences Audible RingerSelect Settings Basic Preferences Language Changing the Audible RingerSelect Settings Basic Preferences Backgrounds Changing the Background PictureSelect Background Prioritize Background Changing the Soft Key Label Color Select Settings Basic Preferences Label ColorMuting the Microphone Adjusting the VolumePolycom SoundPoint IP 450 User Guide Troubleshooting Your Phone Symptom Problem Corrective Action Power and StartupThen select Status Network ControlsLines Line Information. From Access to Screens and SystemsCalling Symptom Problem Corrective Action Brightness on DisplaysTesting Phone Hardware AudioProductivity Suite To test your phone hardware Polycom SoundPoint IP 450 User Guide Polycom UC Software Menu System Page Polycom UC Software Menu System Page Governing Law Service AgreementsPolycom Limited Warranty and Limitation Liability Warranty ExclusiveExclusions Modifications Safety and Compliance Part 15 FCC RulesInstallation Instructions Class B Digital Device or PeripheralRussian Compliance SoundPoint IP Safety and Compliance CE and Vcci MarkAustralia Echo cancellationUse of IP Networks through the Pstn Use of Voice Compression through the PstnUser Guide for the SoundPoint IP 450 Desktop Phone End User License Agreement for Polycom Software Support Services Limitation of Liability Corporate Headquarters Israel OfficeNetherlands Office
Related manuals
Manual 2 pages 22.72 Kb